D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 8 Continuous Flow Introduction, Installation, & Operation
8.4.2 Dual Electric Valve
Installation
To install the electric valve package (refer to Figure 8-6):
1. Position the valve bases 1.3 cm apart.
2. Use the plugs to stopper the ports that will not be connected.
DANGER
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 700 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
3. Loosely attach the tubing lengths from the valve assembly
to the pumps.
4. Allow the bracket to hang vertically and place the straps
around the pressure transducer caps. Tighten the wingnuts.
5. Install the four bracket panhead screws on the bottom of
the bracket.
Plumbing connections
Electrical connections
6. Tighten the tubing nuts.
7. Connect the inlet tube to the supply reservoir. Connect the
outlet tee to your apparatus.
8. Connect the DB-25 cable to the controller rear panel “SFX
220/VALVES” connector (Figure 8-6).
8-14