D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 5 Pump Maintenance & Repair
Figure 5-11 Installing the plastic mounts
8. Be sure that the cylinder is unscrewed several turns. If you
need to use a wrench, we recommend a strap wrench or
wrenches in the Teledyne Isco wrench package (P/N
68-1247-067 for 65DM, 100DM, 100DX, 260D, and 65D;
P/N 68-1247-068 for 500D; P/N 60-1247-093 for 1000D)
which will not mar the cylinder’s outer surface.
9. Center the pump bottom limit sensor with respect to the
mounting screws and tighten them.
10. Raise the top limit sensor to the extent of the slots and
tighten the upper screw.
Now the new limit sensors MUST be calibrated, as explained in
the following section.
5-21