2150EX AV Flow Module - Isco

More documents

Recommendations

Info

2150EX Area Velocity Flow System Safety Information Designed for safety Labels Installation should be completed with adherence to local requirements for ATEX Group II, Category 1G or 2G equipment as appropriate, and should be done by trained and qualified personnel. The purpose of intrinsic safety is to limit the energy available to a given circuit or device to a level where electrical discharge (sparking) cannot ignite the hazardous (flammable or explosive) atmosphere. With no spark ignition possible, safe operation of the equipment in areas with hazardous atmospheres is possible. The durable 2150EX, 2191EX, 2196EX, and 2194EX enclosures are made with ABS plastic embedded with conductive carbon fiber, giving the units low surface resistance to minimize electrostatic energy. The lithium thionyl chloride batteries and the lead acid batteries used in the 2191EX Battery Module operate at a low voltage and are contained in sealed battery packs. The 2150EX system has been designed so that it does not cause physical injury or other harm due to contact. It does not produce excessive surface temperature or dangerous radiation. When used properly, it does not present any non-electrical dangers. Read all labels carefully before installing the equipment! The 2150EX and its components are clearly labeled with color and/or text so you know what can be located in a safe or hazardous area (see figure below). For example, on the label shown below, light blue is used to indicate the intrinsically safe end and yellow to indicate the non-protected end of the cable and connector. Example of Safe and Hazardous Area Labeling on RS232EX Cable Some system components have an X marking, as shown in the example on the following page. The X marking indicates that there are special conditions that must be met to ensure intrinsic safety. In the case of the sensor cable, there is a danger of static electricity. The cable is labeled with a warning telling you that you should not rub the sensor with a dry cloth, as this might generate static electricity. viii
2150EX Area Velocity Flow System Safety Information X-Marking WARNING ELECTROSTATIC HAZARD DO NOT RUB CLEAN WITH DAMP CLOTH ONLY AV2150EX Sensor Cable Labels Where applicable, the labels contain other information, such as voltage, serial number identification, etc. For example, the label shown below indicates the maximum input voltage (U i ), input current (I i ), and input power (P i ) that can be applied to the 2150EX network port without invalidating intrinsic safety. It also shows the internal capacitance (C i ), and internal inductance (L i ) that must be allowed by any power source. Example of 2150EX Label When you compare the 2150EX label in the figure above with the 2191EX label in the figure below, you can see they provide a helpful reference so you can make sure your connections are safe. Example of 2191EX Label ix
Page 1: 2150EX Area Velocity Flow Module In
Page 5 and 6: 2150EX Area Velocity Flow System Sa
Page 7: 2150EX Area Velocity Flow System Sa
Page 11 and 12: 2150EX Area Velocity Flow System Ta
Page 13 and 14: 2150EX Area Velocity Flow System Ta
Page 15 and 16: 2150EX Area Velocity Flow System Se
Page 59 and 60:
2150EX Area Velocity Flow System Se
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
2150EX Area Velocity Flow System Ap
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
2150EX Area Velocity Flow System In
Page 137:
DECLARATION OF CONFORMITY Applicati
Page 143 and 144:
DECLARATIONOFCONFORMITY Applic
Page 145 and 146:
DECLARATION OF CONFORMITY Applicati
Page 147:
Teledyne Isco One Year Limited Warr
show all

2150EX AV Flow Module - Isco

Create successful ePaper yourself

Delete template?

Save as template?