2150EX AV Flow Module - Isco

More documents

Recommendations

Info

2150EX Area Velocity Flow System Section 2 Preparation and Installation Two interface cable assemblies are available from Teledyne Isco: The CA75EX-CTL, 75 meter (60-2004-337) provides the maximum length for powering two 2150EX modules with sensors. The CA150EX-CTL, 150 meter (60-2004-338) provides the maximum length for powering one 2150EX module with sensor. Maximum length may require reduced-power program settings. Contact the factory for custom-ordered lengths less than standard. Install the interface cables without coiling and cut to the appropriate practical length. Wire the interface cable to the 2194EX using the Network Interface Connector Wiring Kit (60-2004-468), referring to Figures 2-13 through 2-17. Always comply with the clearly labeled entity parameters for hazardous location installations. Locking ring Socket insert Locking cap Main body Gland Gland cage Gland nut (When using conduit, replace with appropriate conduit fitting.) Figure 2-14 Network cable connector and wiring Observe intrinsic safety requirements regarding proximity to external sources of potential electric or magnetic interference. Refer to IEC 10079-14 Section 12.2.2.5 on installation of cables and wiring. WARNING Do not coil the interface cable; this will form an inductor and create a hazard. The cable should be kept as short as is practical. Teledyne Isco strongly recommends that you route the interface cable through conduit between the safe and hazardous areas. Two different sizes of conduit fittings are provided with the connector wiring kit (Figure 2-15). 2-22
2150EX Area Velocity Flow System Section 2 Preparation and Installation 1/2” NPT (20MM) Thread 1” NPT (32MM) Thread Figure 2-15 Network cable conduit fittings WHT/GRN 1 ORN/WHT 6 GRN/WHT 2 7 Drain WHT/ORN 5 3 WHT/BLU 4 BLU/WHT Figure 2-16 Wiring the socket insert Note To disassemble the network cable connector for wiring, turn the cap over and use as a key to unscrew the locking ring (Figure 2-17). 2-23
Page 1: 2150EX Area Velocity Flow Module In
Page 5 and 6: 2150EX Area Velocity Flow System Sa
Page 11 and 12: 2150EX Area Velocity Flow System Ta
Page 13 and 14: 2150EX Area Velocity Flow System Ta
Page 15 and 16: 2150EX Area Velocity Flow System Se
Page 47: 2150EX Area Velocity Flow System Se
Page 93 and 94: 2150EX Area Velocity Flow System Ap
Page 99 and 100:
2150EX Area Velocity Flow System Ap
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
2150EX Area Velocity Flow System In
Page 137:
DECLARATION OF CONFORMITY Applicati
Page 143 and 144:
DECLARATIONOFCONFORMITY Applic
Page 145 and 146:
DECLARATION OF CONFORMITY Applicati
Page 147:
Teledyne Isco One Year Limited Warr
show all

2150EX AV Flow Module - Isco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?