2150EX AV Flow Module - Isco
2150EX AV Flow Module - Isco
2150EX AV Flow Module - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>2150EX</strong> Area Velocity <strong>Flow</strong> System<br />
Section 2 Preparation and Installation<br />
X Marking<br />
2194EX<br />
Network<br />
Connector<br />
<br />
<br />
<br />
<br />
<br />
<br />
H<br />
<br />
<br />
Figure 2-13 2194EX labels and cable connector<br />
2.5.1 Installation Example The following steps may be used as a summary guide to install a<br />
basic, permanent <strong>2150EX</strong> system, including the <strong>2150EX</strong> module,<br />
the 2194EX power module, and an <strong>AV</strong><strong>2150EX</strong> sensor. The setup<br />
will look similar to Figure 2-3.<br />
1. Inspect <strong>2150EX</strong> and 2194EX module desiccant (2.4.2).<br />
2. Install the interface cable.<br />
3. Assemble the system.<br />
a. Install the <strong>2150EX</strong> module.<br />
b. Install the 2194EX module in the safe area.<br />
c. Attach the <strong>AV</strong><strong>2150EX</strong> sensor cable to the <strong>2150EX</strong> module<br />
(2.7).<br />
4. Install the <strong>AV</strong><strong>2150EX</strong> sensor in the flow stream (2.7.1).<br />
5. Connect the interface cable between the <strong>2150EX</strong> and<br />
2194EX.<br />
6. Connect the interrogation cable to the 2194EX and connect<br />
to the site with <strong>Flow</strong>link software.<br />
a. Create the site by Quick Connecting to the modules.<br />
b. Set up the site and module settings.<br />
c. Disconnect from the site and replace all protective caps.<br />
2.5.2 Interface Cable Connection to the 2194EX module requires a network interface<br />
cable. The cable’s molded connector plug will connect to the<br />
bottom communication port of the <strong>2150EX</strong> module. The other end<br />
will enter the safe area, usually via conduit.<br />
2-21
Change language