2150EX AV Flow Module - Isco

More documents

Recommendations

Info

2150EX Area Velocity Flow System Section 2 Preparation and Installation 2.4.6 2191EX: Installing Batteries The 2191EX Battery Module requires two LTC2191EX 8 volt lithium battery packs (P/N 68-2000-022) or two SLA2191EX 8 volt lead-acid battery packs (P/N 68-2000-023). These packs are sealed and explosion protected, so they can be safely installed in a potentially explosive atmosphere. WARNING Substitution of components will impair intrinsic safety. Battery Pack Door Figure 2-10 Illustration of Battery Packs Figure 2-11 Label Markings for LTC2191EX and SLA2191EX Battery Packs 2-18
2150EX Area Velocity Flow System Section 2 Preparation and Installation CAUTION To avoid overloading the fuses in the LTC2191EX lithium battery packs, disconnect the 2150EX module(s) before installing or replacing the lithium battery packs. The SLA2191EX lead-acid battery packs do not contain fuses, and do not require that the 2150EX module(s) be disconnected. If you are installing the LTC2191EX lithium battery packs, first disconnect the 2150EX module(s). If you are installing the SLA2191EX lead-acid battery packs, it is not necessary to disconnect the 2150EX module(s). Then: 1. Remove the battery door. To remove the door, turn it 1 /4 turn counter-clockwise and pull it from the Battery Module. 2. Align the connectors and insert the new battery pack into the Battery Module. 3. Check the humidity indicator disk inside the door. (See section 2.4.2.) 4. Replace the door. Align the small triangle on the door with the triangle above the battery port, push inward, and rotate 1 /4 turn clockwise so the curved arrow is at the top of the door. Repeat steps 1 through 4 to install the second battery pack. When finished, reconnect the 2150EX module(s). Note The battery packs should always be replaced as a pair. Never mix old and new batteries. Battery packs should be disposed of according to local battery disposal regulations. The lead-acid battery packs should be recharged or recycled. 2-19
Page 1: 2150EX Area Velocity Flow Module In
Page 5 and 6: 2150EX Area Velocity Flow System Sa
Page 11 and 12: 2150EX Area Velocity Flow System Ta
Page 13 and 14: 2150EX Area Velocity Flow System Ta
Page 15 and 16: 2150EX Area Velocity Flow System Se
Page 43: 2150EX Area Velocity Flow System Se
Page 93 and 94: 2150EX Area Velocity Flow System Ap
Page 95 and 96:
2150EX Area Velocity Flow System Ap
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
2150EX Area Velocity Flow System In
Page 137:
DECLARATION OF CONFORMITY Applicati
Page 143 and 144:
DECLARATIONOFCONFORMITY Applic
Page 145 and 146:
DECLARATION OF CONFORMITY Applicati
Page 147:
Teledyne Isco One Year Limited Warr
show all

2150EX AV Flow Module - Isco

Create successful ePaper yourself

Delete template?

Save as template?