2150EX AV Flow Module - Isco
2150EX AV Flow Module - Isco
2150EX AV Flow Module - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>2150EX</strong> Area Velocity <strong>Flow</strong> System<br />
Section 2 Preparation and Installation<br />
CAUTION<br />
The module should not remain connected to the <strong>Isco</strong> Model<br />
965 charger after the Battery Voltage measured at TP1<br />
reaches 13.8 volts. Over time, overcharging can decrease the<br />
water content of the batteries’ electrolyte, causing premature<br />
aging.<br />
3. The <strong>Isco</strong> Model 963 desktop charger has a single, 2-pin<br />
amphenol connector port. The charger is user-switched for<br />
120/240VAC, 50/60Hz applications.<br />
The 963 is a float mode charger, using a lower voltage,<br />
which reduces the risk of overcharging. It can fully charge<br />
the module in 16-24 hours maximum.<br />
Charging connections<br />
1. Teledyne <strong>Isco</strong> offers the CB edge adaptor cable<br />
(60-2004-547) for use with chargers 2 & 3 (Figure 2-9).<br />
Simply push the 2-pin amphenol connector into the connector<br />
port on your <strong>Isco</strong> charger, and the card edge connector<br />
onto the circuit board.<br />
Polarity is observed by the design, as the cable can only fit<br />
onto the installed board in one direction.<br />
Part #60-2004-547<br />
Connect edge connector here<br />
Figure 2-9 2196EX charging adaptor cable<br />
2-17