2150EX AV Flow Module - Isco
2150EX AV Flow Module - Isco
2150EX AV Flow Module - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>2150EX</strong> Area Velocity <strong>Flow</strong> System<br />
Section 2 Preparation and Installation<br />
Figure 2-4 Assembling a basic portable system<br />
Connecting the <strong>Module</strong>s<br />
To connect the <strong>2150EX</strong> and 2191EX/2196EX modules, refer to<br />
the following instructions and Figure 2-4.<br />
1. On the top of the battery module, remove the cap and stow<br />
it on the holder. This exposes the communication connector.<br />
2. Prepare the battery module’s communication connector:<br />
a. Inspect the connector. It should be clean and dry. Damaged<br />
O-rings must be replaced. Spare O-rings<br />
(P/N 202-1006-69) are supplied in the 2191EX maintenance<br />
kit (60-2009-332).<br />
b. Coat the O-ring’s sealing surface with a silicone lubricant.<br />
(A small quantity of lubricant is supplied in the<br />
maintenance kit.)<br />
CAUTION<br />
Do not use petroleum-based lubricants. Petroleum-based<br />
lubricants will cause the O-ring to swell and eventually deteriorate.<br />
Aerosol silicone lubricant sprays often use petroleum<br />
based propellants. If you are using an aerosol spray, allow a<br />
few minutes for the propellant to evaporate before proceeding.<br />
3. Place the carrying handle on the battery module. (If you<br />
are stacking two <strong>2150EX</strong> modules on top of the<br />
2191EX/2196EX, position the handle between the <strong>2150EX</strong><br />
modules.)<br />
2-10