2150EX AV Flow Module - Isco

More documents

Recommendations

Info

2150EX Area Velocity Flow System Appendix C Material Safety Data Sheets Section 16 Other Information HMIS Hazardous Materials Identification System Health Flammability Reactivity HMIS Rating 0 - minimal hazard, 1 - slight hazard, 2 - moderate hazard, 3 - serious hazard, 4 - severe hazard 0 0 0 This MSDS was prepared by: George E. Mckedy Senior Applications Development Specialist Multisorb Technologies, Inc. This data and recommendations presented in this data sheet concerning the use of our product and the materials contained therein are believed to be correct but does not purport to be all inclusive and shall be used only as a guide. However, the customer should determine the suitability of such materials for his purpose before adopting them on a commercial scale. Since the use of our products is beyond our control, no guarantee, expressed or implied, is made and no responsibility assumed for the use of this material or the results to be obtained therefrom. Information on this form is furnished for the purpose of compliance with Government Health and Safety Regulations and shall not be used for any other purposes. Moreover, the recommendations contained in this data sheet are not to be construed as a license to operate under, or a recommendation to infringe, any existing patents, nor should they be confused with state, municipal or insurance requirements, or with national safety codes. C-12
2150EX Area Velocity Flow System Appendix D General Safety Procedures The intrinsically safe 2150EX is intended for use in potentially explosive atmospheres, and complies with ATEX Directive 94/9/EC. The 2150EX is Group II, Category 1G or 2G equipment for use in gas hazard zones 0, 1, and 2. For safety information specific to the 2150EX, refer to the Safety Information section at the front of this manual. The safety of the personnel who use the 2150EX is a critical consideration. The following general safety procedures, applicable to working in and around manholes and sewers, are those used by Black & Veatch, a respected consulting firm, and are published here by permission. Field personnel must keep safety uppermost in their minds at all times. When working above ground, rules of common sense and safety prevail. However, when entering manholes, strict safety procedures must be observed. Failure to do so could jeopardize not only your own life, but also the lives of other crew members. CAUTION Before you install any flow logger, you must take the proper safety precautions. The following discussion of safety procedures offers only general guidelines. Each situation in which you install a flow logger varies. You must take into account the individual circumstances of each installation. Additional safety considerations, other than those discussed here, may be required. Check applicable guidelines, codes, and regulations of federal, state, city, and county agencies. D.1 Hazards There are many hazards connected with entering manholes. Some of the most common hazards are: • Adverse Atmosphere–The manhole may contain flammable or poisonous gases or the atmosphere may be deficient in oxygen. Forced ventilation may be necessary. • Deteriorated Rungs–Manhole steps may be corroded and not strong enough to support a man. It may be difficult to inspect the rungs because of poor lighting. • Traffic–Whenever manholes are located in the traveled way, barricades and warning devices are essential to direct traffic away from an open manhole. • Falling Objects–Items placed near the manhole opening may fall and injure a worker in the manhole. All loose items should be kept away from the manhole opening. D-1
Page 1:
2150EX Area Velocity Flow Module In
Page 5 and 6:
2150EX Area Velocity Flow System Sa
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
2150EX Area Velocity Flow System Ta
Page 13 and 14:
2150EX Area Velocity Flow System Ta
Page 15 and 16:
2150EX Area Velocity Flow System Se
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76: 2150EX Area Velocity Flow System Se
Page 93 and 94: 2150EX Area Velocity Flow System Ap
Page 125: 2150EX Area Velocity Flow System Ap
Page 135 and 136: 2150EX Area Velocity Flow System In
Page 137: DECLARATION OF CONFORMITY Applicati
Page 143 and 144: DECLARATIONOFCONFORMITY Applic
Page 145 and 146: DECLARATION OF CONFORMITY Applicati
Page 147: Teledyne Isco One Year Limited Warr
show all

2150EX AV Flow Module - Isco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?