2150EX AV Flow Module - Isco

More documents

Recommendations

Info

2150EX Area Velocity Flow System Appendix C Material Safety Data Sheets Material Safety Data Sheet Indicating Silica Gel Manufacturer : Address: MULTISORB TECHNOLOGIES, INC. (formerly Multiform Desiccants, Inc.) 325 Harlem Road Buffalo, NY 14224 Identity (Trade Name as Used on Label) MSDS Number* : CAS Number* : Phone Number (For Information): 716/824-8900 Date Prepared: July 6, 2000 Emergency Phone Number: 716/824-8900 Prepared By* : G.E. McKedy Section 1 - Material Identification and Information M75 Components - Chemical Name & Common Names (Hazardous Components 1% or greater; Carcinogens 0.1% or greater) %* OSHA PEL Silica Gel SiO 2 98.0 6mg/m 3 (total dust) Cobalt Chloride >2.0 0.05mg/m 3 (TWA cobalt metal dust & fume) Non-Hazardous Ingredients TOTAL 100 ACGIH TLV 10mg/m 3 (total dust) .05mg/m 3 (Cobalt, TWA) OTHER LIMITS RECOMMENDE D Section 2 - Physical/Chemical Characteristics Boiling N/A Point Vapor Pressure N/A (mm Hg and Temperature Vapor N/A Density (Air =1) Solubility Insoluble, but will adsorb moisture. in Water Appearance Purple crystals, no odor. and Odor Specific Gravity (H 20 = 1) Melting Point Evaporation Rate (__________=1) Water Reactive N/A 2.1 N/A Not reactive, but will adsorb moisture. Section 3 - Fire and Explosion Hazard Data Flash Point and N/A Auto-Ignition N/A Flammability Limits in N/A LEL UEL Methods Used Temperature Air % by Volume Extinguisher Dry chemical, carbon dioxide and foam can be used. Media Special Fire Water will generate heat due to the silica gel which will adsorb water and liberate heat. Fighting Procedures Unusual Fire and Explosion Hazards When exposed to water, the silica gel can get hot enough to reach the boiling point of water. Flooding with water will reduce the temperature to safe limits. Section 4 - Reactivity Hazard Data STABILITY Stable Unstable Incompatibility (Materials to Avoid) Hazardous Decomposition Products *Optional Conditions To Avoid Water. HAZARDOUS POLYMERIZATION May Occur Moisture and high humidity environments. Carbon dioxide, carbon monoxide, water Conditions To Avoid None. Indicating Silica Gel C-6
2150EX Area Velocity Flow System Appendix C Material Safety Data Sheets Section 5 - Health Hazard Data Page 2 PRIMARY ROUTES Inhalation Ingestion CARCINOGEN NTP OSHA OF ENTRY Skin Absorption Not Hazardous LISTED IN IARC Monograph Not Listed HEALTH HAZARDS Acute May cause eye, skin and mucous membrane irritation. Chronic Prolonged inhalation may cause lung damage. Signs and Symptoms Drying and irritation. of Exposure Medical Conditions Asthma. Generally Aggravated by Exposure EMERGENCY FIRST AID PROCEDURES - Seek medical assistance for further treatment, observation and support if necessary. Eye Contact Flush with water for at least 15 minutes. Skin Wash affected area with soap and water. Contact Inhalation Remove affected person to fresh air. Ingestion Drink at least 2 glasses of water. Section 6 - Control and Protective Measures Respiratory Protection Use NIOSH approved dust mask or respirator. (Specify Type) Protective Light cotton gloves. Eye Protection Safety glasses. Gloves VENTILATION Local Exhaust Mechanical (General) Special TO BE USED Other (Specify) Other Protective None. Clothing and Equipment Hygienic Work Avoid raising dust. Avoid contact with skin, eyes and clothing. Practices Section 7 - Precautions for Safe Handling and Use/Leak Procedures Steps to be Taken if Material Sweep or vacuum up and place the spilled material in a waste disposal container. Avoid raising dust. Is Spilled Or Released Waste Disposal Dispose in an approved landfill according to federal, state and local regulations. Methods Precautions to be Cover promptly to avoid blowing dust. Wash after handling. Taken In Handling and Storage Other Precautions and/or Special Keep in sealed containers away from moisture. The silica gel will readily adsorb moisture. Hazards *Optional Indicating Silica Gel C-7
Page 1:
2150EX Area Velocity Flow Module In
Page 5 and 6:
2150EX Area Velocity Flow System Sa
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
2150EX Area Velocity Flow System Ta
Page 13 and 14:
2150EX Area Velocity Flow System Ta
Page 15 and 16:
2150EX Area Velocity Flow System Se
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70: 2150EX Area Velocity Flow System Se
Page 93 and 94: 2150EX Area Velocity Flow System Ap
Page 119: 2150EX Area Velocity Flow System Ap
Page 135 and 136: 2150EX Area Velocity Flow System In
Page 137: DECLARATION OF CONFORMITY Applicati
Page 143 and 144: DECLARATIONOFCONFORMITY Applic
Page 145 and 146: DECLARATION OF CONFORMITY Applicati
Page 147: Teledyne Isco One Year Limited Warr
show all

2150EX AV Flow Module - Isco

Create successful ePaper yourself

Delete template?

Save as template?