2150EX AV Flow Module - Isco

More documents

Recommendations

Info

2150EX Area Velocity Flow System Safety Information For example, the 2150EX network port cannot have an input voltage greater than 9.282V. When you look at the label on the power source (in this case the 2191EX), you can see that the maximum output voltage is 9.282V. From this you know that you can safely connect the two, and will not be providing too much voltage to the 2150EX unit. Note This information is not intended to fully explain entity parameters. Other publications should be referenced for more detailed explanations. Installation Repair and Maintenance Teledyne Isco, Inc. Technical Service Dept. P.O. Box 82531 Lincoln, NE 68501 USA Phone: (800) 228-4373 (402) 464-0231 FAX: (402) 465-3085 E-mail: IscoService@teledyne.com Installation of the 2150EX system is described in this manual. Typical round-pipe installations are shown in Figures 2-1 and 2-2, and Appendix E provides information on general safety procedures for work in manholes and sewers. When the equipment is installed in accordance with the instructions in this manual, it will not be subjected to dangerous mechanical or thermal stresses. It should not be installed where it may be attacked by existing or foreseeable aggressive substances that could damage the module enclosures. The enclosures are made of Acrylonitrile Butadiene Stytene (ABS) plastic. Substances that may cause damage include organic solvents (ketones and esters, aromatic and chlorinated hydrocarbons), alcohols, hydrocarbons, fuels, and UV radiation. Refer to Section 5 of this manual for instructions regarding periodic maintenance of the 2150EX and its components. The internal components of the 2150EX System are not user-serviceable. The case is completely sealed to protect the internal components. If you think your module requires repair, contact Teledyne Isco’s Technical Service Department. Rapidly failing desiccant may indicate a crack. WARNING Any cracks in the module case will impair the safety protection. If this occurs, return the unit to Teledyne Isco for a replacement. Components of the AV2150EX Sensor are encapsulated in plastic resin and are not user-serviceable. If any part of the AV Sensor fails, it must be replaced. x
2150EX Area Velocity Flow System Table of Contents Section 1 Introduction 1.1 Product Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 1.1.1 2150EX Area Velocity Flow System Overview . . . . . . . . . . . . . . . . . . . . . . . 1-2 1.1.2 Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 1.1.3 Velocity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 1.1.4 Flow Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 1.1.5 Total Flow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 1.1.6 Data Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 1.2 Identifying Module Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 1.3 Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-7 Section 2 Preparation and Installation 2.1 Unpacking Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1 2.2 Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2 2.2.1 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2 2.2.2 Locating the Site . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 2.2.3 Channels Without a Primary Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 2.2.4 Channels With a Primary Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 2.2.5 2150EX and AV Sensor Mounting Considerations . . . . . . . . . . . . . . . . . . . 2-3 2.3 Site Examples . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4 2.4 Portable Installations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-8 2.4.1 Installation Example . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-8 2.4.2 Inspecting the Desiccant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-8 2.4.3 Assembling the System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-9 2.4.4 Zone 1 Battery Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-12 2.4.5 Charging the Zone 1 Battery Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-14 2.4.6 2191EX: Installing Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-18 2.5 Permanent Installations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20 2.5.1 Installation Example . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-21 2.5.2 Interface Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-22 2.6 Network Communication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-24 2.6.1 EX Network Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-25 2.6.2 Connecting to a Computer for Interrogation . . . . . . . . . . . . . . . . . . . . . . . 2-25 2.6.3 Connecting to a 2100 Series Network Device . . . . . . . . . . . . . . . . . . . . . . . 2-26 2.6.4 RS232 Communication Cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-28 2.7 Connecting the AV2150EX Sensor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-29 2.7.1 Positioning the AV Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-30 2.8 Mounting Rings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-32 2.8.1 Spring Rings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-32 2.8.2 Scissors Mounting Ring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-34 2.8.3 Completing the AV Sensor Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-36 2.9 Final Installation Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-37 2.9.1 Program the Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-37 xi
Page 1: 2150EX Area Velocity Flow Module In
Page 5 and 6: 2150EX Area Velocity Flow System Sa
Page 7 and 8: 2150EX Area Velocity Flow System Sa
Page 9: 2150EX Area Velocity Flow System Sa
Page 13 and 14: 2150EX Area Velocity Flow System Ta
Page 15 and 16: 2150EX Area Velocity Flow System Se
Page 61 and 62:
2150EX Area Velocity Flow System Se
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
2150EX Area Velocity Flow System Ap
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
2150EX Area Velocity Flow System In
Page 137:
DECLARATION OF CONFORMITY Applicati
Page 143 and 144:
DECLARATIONOFCONFORMITY Applic
Page 145 and 146:
DECLARATION OF CONFORMITY Applicati
Page 147:
Teledyne Isco One Year Limited Warr
show all

2150EX AV Flow Module - Isco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?