Flowlink 5.1 Software Instruction Manual - Isco

Isco Flowlink 5.1 ® Software
Site Window - 2100
That is, the sampler would stay disabled until a
significant rainfall event occurred. This Rain Event
condition would read “When 2105 Interface
Module:Rainfall is greater than or equal to 0.25 inches
in a 60 minute period following a ‘dry’ period of 1 Week.”
To define the Rain Event condition:
1. Select a 2105 Rainfall measurement from the pull down
list.
2. Enter the threshold amount of rainfall and units of
measure from the pull down list.
3. Enter a time duration in minutes to define the rate of
increased rainfall.
4. Define the “dry” period (period when rate of rainfall is
below the threshold).
NOTE: To specify a Rain Event for any time rainfall is at or
above the threshold, enter a “dry” period of zero.
Report
Network Resolution
- 2100
This window displays text reports downloaded from the
instrument or a list of alarm events from an attached 2103 or
2105 modem module. Refer to the instrument’s instruction
manual for more information on reading the individual reports.
For instrument reports, this window has a 50,000 character limit
and may cause very large reports or histories to appear
incomplete. To view complete text reports exceeding this limit, or
to print the report, click the Save To File button. Then, open the
file in a text editor such as Notepad, or your word processing
application.
For alarm-event lists, there is a 20 line alarm-event limitation.
After the 20 alarm-event limit is reached, the latest alarm event
will be posted and the oldest alarm event will be removed from
the list.
The Network Resolution screen will appear when a 2100 module
has been replaced or a 2100 module has been added to the
network. You need to indicate what action should be taken to
resolve the situation.
Connected Modules - The physical module(s) that were found
at the site are listed on the left side of the screen. If you click the
ID button to the left of a listed module, the module will be
identified by illuminating its LED or performing an identifying
action (such as a beep from the Field Wizard).
Database Site Definitions - The modules that Flowlink knows
were previously at the site are listed on the right side of the
screen. Where possible, these will be matched with the connected
modules listed on the left side of the screen.
If you click the ! button to the right of module, a window will be
displayed that contains information about the connected module
and selected module from the database. This information
includes the Site Name, Module Name, Module Type, Module
72