Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Isco</strong> <strong>Flowlink</strong> <strong>5.1</strong> ® <strong>Software</strong><br />
Site Window - 2100<br />
and Stop date and time. For Weekly, enter the Start and Stop day<br />
of week and time. For Daily, enter the Start and Stop time. For<br />
Mon-Fri, enter the Start and Stop time.<br />
When you have made your selections, click OK.<br />
Modem Power<br />
Pulse Doppler<br />
Support - 2105<br />
Modbus Input - 2105<br />
The “Power Modem When” allows you to control the On/Off time<br />
of a 2103/5 Cellular Modem through the use of equations. When<br />
the conditions of an equation are true, the site will turn the 2103/<br />
5 Cellular Modem on. When false, the modem is not powered to<br />
conserve battery power.<br />
Click the Set Equation button to build an equation.<br />
The ADFM tab of the Site window is used to communicate with<br />
Pulse Doppler devices attached to a 2105 Interface Module.<br />
NOTE: Pulse Doppler input and Modbus input cannot be used<br />
simultaneously in the same system.<br />
The 2105 Interface Module can display this tab. From this tab<br />
you may:<br />
• enable Pulse Doppler device communication and data<br />
retrieval.<br />
• select the optimal baud rate for communication with the<br />
device(s).<br />
• enable pushed data from the device(s).<br />
For detailed information about setting up the Pulse Doppler<br />
device(s) and 2105-Pulse Doppler interfacing, see the user<br />
manuals for the 2105 module and the Pulse Doppler<br />
instrument(s).<br />
The Modbus tab of the Site window is used to configure data<br />
input to the 2105 module using Modbus ASCII or RTU protocol.<br />
The 2105 Interface Module can display this tab. You must set up<br />
and configure your monitoring/control system and Modbus<br />
device(s) before adding and configuring the 2105 module.<br />
Note: Modbus and Pulse Doppler input cannot be used<br />
simultaneously in the same system.<br />
From the Modbus tab you may:<br />
• Specify the device name and address<br />
• Specify data and measured parameter(s)<br />
• Add or remove devices<br />
For complete information about configuring Modbus input, refer<br />
to the Modbus Input section of your 2105 user manual.<br />
Equation Builder<br />
The Equation Builder window is used to create equations from<br />
various site conditions that can be used to generate alarms, log<br />
or push measurement data at secondary rates, and conserve<br />
power by turning on equipment only when needed.<br />
67
Change language