Flowlink 5.1 Software Instruction Manual - Isco

Isco Flowlink 5.1 ® Software
Site Window - 2100
11. TAP/SMS/SVR: Click the Set Alarm button and define
the alarm condition or multiple conditions using the
Equation Builder window.
After entering the phone number information and defining
condition, click Apply or press F9 to update the settings in the
module.
Server Alarms
Analog Outputs
The Server Alarms tab of the Server Options window is used to
set up alarm notification if the Flowlink Server fails to receive
pushed data from a site within a user-specified duration, or when
a user-defined alarm condition is met. These server alarms are
delivered as E-mail or SMS text messages.
If you are using Isco’s 2108 Analog Output module, the Channel
tabs on the Site window let you set up information for the analog
output channels.
Output Channel Name - Enter a name for the output channel.
The output channel percentage and the measurement output
value calculated by Flowlink will display below the channel
name.
Modify the Measurement Input for This Channel - Use the
drop down list to select the input you want to measure (such as
level or velocity). Indicate a minimum and maximum input range
(minimum = 0% on analog output; maximum = 100%).
Modify the Data Recording for This Channel - Use the
Update Interval field to set how often the output channel is
updated.
Manual Control - The Manual Control button is used to
temporarily override the channel’s output and is used when you
are calibrating equipment. When you click the button, the
Manual Control dialog box will appear. Set the output channel
percentage by selecting one of the percentages displayed, or by
selecting Custom and entering a percentage amount. Click the
Set Output Channel Percentage button. The output will change
to the manual setting; the dialog box will remain until you click
Cancel. Then the output will revert to your previous settings.
Power Control This tab of the Site window controls the On/off times for a 2102
Wireless Communication Module or 2103/5 Cellular Modem
Module.
Set Wireless
Schedule
Rather than have the 2102 Wireless Module continually enabled,
you can specify a time period for when the module is powered up.
Type - Select the type of schedule you want: Specific, Weekly,
Daily, or Mon-Fri. When you enter a Specific time period, the
wireless will be activated only during that specified period.
Weekly, Daily, or Mon-Fri time periods will be ongoing.
Start/Stop - The Start and Stop display will vary, depending on
what you selected for Type. For Specific, you will enter a Start
66