Flowlink 5.1 Software Instruction Manual - Isco

Isco Flowlink 5.1 ® Software
Site Window - 2100
• Set the measurement units by selecting an option from
the pull-down list.
• Set the rain volume per bucket tip.
• Set Up Data Storage...
• Diagnostics... - Downloads and displays a text file from
the module. This file reports the performance of the
module and rain gauge.
• Hide in Measurements check box - when left unchecked,
the Measurements tab displays this reading. If checked,
the Measurements tab does not display this reading.
If you have made any changes, click the Apply button to update
the settings in the module.
Sampler Control -
2100 (2105)
Sampler Enable
Sampler Pacing
The Sampler tab of the Site window displays the settings used by
a 2105 Interface Module to control a connected sampler. The
2105 can control two sampler functions - sampler enable and
sampler pacing.
The 2105 Interface Module can display this tab. From this tab
you may:
• View the Module and Measurement name.
• View the sampler’s current Bottle Number and Enable
Status.
• Set Sampler Enable conditions.
• Hide in Measurements check box - when left unchecked,
the Measurements tab displays this reading. If checked,
the Measurements tab does not display this reading.
If you have made any changes, click the Apply button to update
the settings in the module.
Set up the sampler enable by choosing one of the three options in
the Sampler Enable box:
Always - the sampler remains enabled regardless of changing
conditions.
Never - the sampler remains disabled.
On Trigger - The sampler is enabled when a user-defined
condition is met. Select Latch to keep the sampler enabled after
the condition is no longer true. The enabled state will continue
until the Reset Latch button is pressed.
From the Sampler Pacing box, select either None or Flow Paced.
• None - The 2105 will not send flow pulses.
• Flow Paced - paces the sampler at a rate proportional to
the flow rate by using volume intervals. Use the Flow
Pulse setting to set the interval.
62