Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Isco</strong> <strong>Flowlink</strong> <strong>5.1</strong> ® <strong>Software</strong><br />
Site Window - 2100<br />
Velocity - 2100<br />
Zero Level Offset<br />
The Velocity tab of the Site window is used to view or change<br />
velocity measurement settings. Access this tab by clicking on the<br />
“Velocity” label on the Measurements tab.<br />
Modules able to read liquid velocities can display this tab. From<br />
this tab you may:<br />
• View the Module and Measurement name.<br />
• View the current Velocity measurement.<br />
• Set the measurement units by selecting an option from<br />
the pull-down list.<br />
• Enter a Zero level offset value.<br />
• Control how flow readings are recorded if the module is<br />
unable to measure velocity. Check the “Set flow rate to<br />
zero if no velocity data” to record the flow rate as “0.000”<br />
when the module is unable to take a velocity reading. If<br />
the check box is left blank, a no data code will be<br />
recorded instead.<br />
• Prevent interference from other velocity measurements.<br />
If the area velocity sensors of a multiple-module site are<br />
placed near each other, it is important that each sensor<br />
receives its own transmitted signal. Check this box when<br />
multiple area velocity sensors are located in the same<br />
channel so that the site will ensure only one velocity<br />
measurement is taken at a time. Leave this box<br />
unchecked for single-module sites or multiple module<br />
sites measuring velocities in separate channels.<br />
• Positive Velocities Only check box. Select this box to log<br />
only positive velocities; negative velocities (reversed<br />
flows) are stored as zero. To log both positive and<br />
negative velocities leave this box blank.<br />
• Set Up Data Storage…<br />
• Diagnostics… - Downloads and displays a text file from<br />
the module. This file reports the performance of the<br />
module and its sensor. The measurement type will<br />
determine which information is included in this report.<br />
• Hide in Measurements check box - when left unchecked,<br />
the Measurements tab displays this reading. If checked,<br />
the Measurements tab hides this reading.<br />
If you have made any changes, click on the Apply button to<br />
update the settings in the module.<br />
Area Velocity sensors are sometimes mounted higher on the side<br />
of the channel to avoid silting.<br />
• If the Area Velocity sensor is mounted on the side of the<br />
channel, enter the vertical distance from the bottom<br />
center of the channel. Refer to the instrument’s<br />
instruction manual to calculate this distance.<br />
• If the Area Velocity sensor is mounted at the bottom of<br />
the channel, simply set the Zero level offset to zero.<br />
58