Flowlink 5.1 Software Instruction Manual - Isco

Isco Flowlink 5.1 ® Software
Site Window - 2100
• Quality - a percentage that represents the number of
valid readings out of the total number of readings.
The Calculated Flow button opens a window that allows flow
rates to be calculated after retrieving the data. This can conserve
memory and reduce the amount of data that must be transferred
between the instrument and Flowlink.
To view the details of a particular measurement, highlight the
measurement in the lower half of the window and click on the
“Measurement Details” button. Flowlink will then display the
properties of the selected measurement type.
To configure the data storage rate of a particular measurement,
highlight the measurement of interest and click the “Set Up Data
Storage…” button. Flowlink displays the “Data Storage Setup”
window.
The Delete All Data button is active when connected to a 2100
Series site. Clicking this button will delete all of the highlighted
measurement data from the module. This is useful when you
want to clear all of the readings from an instrument. This action
does not delete any data stored in the Flowlink database.
The Pushed Data button opens the Pushed Data configuration
window. Pushed Data allows 2100 Series sites that include a
Modem Module to send data to an enterprise database server.
Notes:
• Flowlink must be connected to the site to view the
current Data Storage information. If Flowlink is Not
Connected, the information displayed on this tab is the
“last known” values.
• Modules report “Time” as one of the measurement types.
It is not a configurable measurement; it is only reported
to indicate the number of readings and the amount of
memory used to store time stamps. The module records
time stamps at the fastest data storage rate of the
remaining measurements.
Calculated Flow
The Calculated Flow window allows you to instruct Flowlink to
automatically calculate a flow based on actual level or areavelocity
readings collected by the instrument. This window is
opened by clicking the Calculated Flow button on the Data tab of
the site window.
Use this window to add Calculated Flow data sets to the site.
1. Click the Add button in the Calculated Flow window.
This opens the Flow Conversion List.
2. Select a Flow Conversion from the list and click the OK
button.
2100 Series Only - Because 2100 Series sites may include
several flow modules, you must specify which level and
velocity readings to use for the calculated data set. Use
the Select Level and Velocity window to choose the
modules.
53