Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Isco</strong> <strong>Flowlink</strong> <strong>5.1</strong> ® <strong>Software</strong><br />
Menu Commands<br />
Graphs>Profile<br />
Cross Section<br />
Graphs>Velocity<br />
Graph<br />
Graphs>Velocity<br />
Vectors<br />
Graphs>Amplitude<br />
Selecting the Graphs>Flow Profile>Profile Cross Section menu<br />
option or clicking the Flow Profile button displays a<br />
hydrograph and color contour plot of the flow profile. The Y-axis<br />
represents channel height, and the X-axis represents channel<br />
width. Velocity is represented by different colors.<br />
Selecting the Graphs>Flow Profile>Velocity menu option or<br />
clicking the Velocity Graph button shows the raw Dopplerbased<br />
velocity components measured by each individual beam.<br />
Selecting the Graphs>Flow Profile>Velocity Vectors Graph menu<br />
option or clicking the Velocity Vector Graph button displays<br />
these raw measurements in an XYZ coordinate system to<br />
produce the Vector profiles shown in the XYZ graph.<br />
NOTE: Both the Velocity and Vector graph functions give<br />
niformation about the quality of the ADFM sensor installation<br />
and alignment. In a perfect installation, Beams 1 and 3, and 2<br />
and 4, will be equal in amplitude and opposite in sign. Beams 2<br />
and 4 will be approximately 50% greater in amplitude than 1<br />
and 3.<br />
Selecting the Graphs>Flow Profile>Amplitude Graph menu<br />
option or clicking the Amplitude Graph button shows a<br />
graphical display of the received signal strength. The amplitude<br />
normally decays from a high value near the sensor (bottom of<br />
graph) to a lower value at the end of the profile range (near top of<br />
graph). Large spikes should be expected where the beams hit the<br />
water surface.<br />
Graphs>Correlation<br />
Selecting the Graphs>Flow Profile>Correlation Graph menu<br />
option or clicking the Correlation Graph button shows a<br />
measure of the quality of the processed velocity information.<br />
Lower correlation values (e.g., below 100) are an indication of<br />
poor quality data. Higher correlation values (e.g., above 150) may<br />
indicate external interference or the presence of an acoustic<br />
barrier (such as the surface).<br />
Utilities Command<br />
For the Utilities menu options to be active, you must first have a<br />
database open. The Utilities menu contains the following choices:<br />
• Options: Displays the options window that contains the<br />
default settings for <strong>Flowlink</strong> operations.<br />
• Flow Conversions: A complete listing of flow conversion<br />
methods stored in the database.<br />
• Merge Sites: Allows you to merge site data.<br />
36