Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Isco</strong> <strong>Flowlink</strong> <strong>5.1</strong> ® <strong>Software</strong><br />
graph and selecting the Edit option, or use the Alt+E<br />
keyboard shortcut.<br />
2. Locate the incorrect data and highlight it.<br />
3. Determine the type of reading adjustment that will be<br />
necessary.<br />
• Constant value - changes all of the highlighted<br />
readings to a single value.<br />
• Fixed offset - increases or decreases the highlighted<br />
readings by a fixed amount.<br />
• Proportional - distributes an adjustment<br />
proportionately over selected readings.<br />
• Multiply by Constant Value - multiplies the readings<br />
by a specified constant value. Specify a value greater<br />
than 1 to increase the readings; less than 1 to<br />
decrease the readings.<br />
• Auto Correct - When selected, <strong>Flowlink</strong> will adjust<br />
the highlighted readings to fit adjacent readings.<br />
Because the amount is calculated by <strong>Flowlink</strong>, the<br />
Amount value is not needed.<br />
• Time (minutes) - shifts the highlighted times forward<br />
or backward a fixed amount.<br />
• Restore to Original - removes any corrections made to<br />
the readings to restore it to the original data.<br />
4. Enter the Amount.<br />
5. Click Adjust. <strong>Flowlink</strong> changes the data according to the<br />
Type and Amount. The new readings are displayed on<br />
the table. The graph shows both the original and the new<br />
readings.<br />
6. Click Save Changes.<br />
Sometimes you may find that a combination of adjustment types<br />
may work best to produce the desired results. Repeat the steps<br />
above to apply additional adjustments.<br />
Other Adjustment<br />
Methods<br />
• Copy and Paste - Highlight correct readings and Copy<br />
(Ctrl-C) them. This places the readings on the clipboard.<br />
Highlight the incorrect data and Paste (Ctrl-V). <strong>Flowlink</strong><br />
replaces the readings with those on the clipboard. You<br />
can also copy and paste using the buttons on the toolbar<br />
or using the “Actions” menu options.<br />
• Cut - Highlight the readings to remove and Cut (Ctrl-X)<br />
them. This places them on the clipboard. They will be<br />
available for pasting elsewhere until they are replaced by<br />
another Copy or Cut. Cut can be used to remove<br />
unwanted readings or No Data codes from the data set.<br />
You can also cut readings with the Cut button on the<br />
toolbar or using the Actions>Cut menu option.<br />
• Insert - Highlight the beginning point where you wish to<br />
insert readings. Select Actions>Insert or press Ctrl-I and<br />
complete the entries in the insert window. Insert may be<br />
152