Flowlink 5.1 Software Instruction Manual - Isco

Isco Flowlink 5.1 ® Software
Editor Window
Other Adjustment
Methods
Copy
• Copy and Paste - Highlight correct readings and Copy
(Ctrl-C) them. This places the readings on the clipboard.
Highlight the incorrect data and Paste (Ctrl-V). Flowlink
replaces the readings with those on the clipboard. You
can also copy and paste using the buttons on the toolbar
or using the menu options displayed when you right-click
in the editor window.
• Cut - Highlight the readings to remove and Cut (Ctrl-X)
them. This places them on the clipboard. They will be
available for pasting elsewhere until they are replaced by
another Copy or Cut. Cut can be used to remove
unwanted readings or No Data codes from the data set.
You can also cut readings with the Cut button on the
toolbar.
• Insert - Highlight the beginning point where you wish to
insert readings. Then, right click and select
Insert>Before or Insert>After. The editor then inserts
data from the clipboard (from the last Copy or Cut).
Insert may be used to fill gaps, or to add readings at the
beginning or end of the data. It cannot overwrite valid
readings.
• Click and drag - Single readings can be moved on the
graph by clicking and dragging the point to a new value.
Notes:
• It is possible to insert readings that will not appear in
the timespan currently viewed on the graph and the
table. It may be necessary to move to the previous or next
time span to see the adjustments.
• When Flowlink combines sites to form a line of data on a
graph or report, it will not combine error codes with
readings. Instead, it will report no data.
• New values that you can store in the database are only
limited to the resolution and significant digits for the
data set. Viewing the Data set Properties (Highlight a
data set in the workspace and press Ctrl+F2) will reveal
this information.
• When editing, Flowlink saves both the original and the
edited data. If necessary, the original values can be
restored.
To copy readings displayed in the Editor window, first highlight
the data to copy. Then, do one of the following:
• click the Copy button on the toolbar
• right-click and select Copy from the popup menu
• press Ctrl-C on the keyboard.
When you copy data, the data will be stored on a clipboard so
that you can paste it elsewhere, including another data set (of
the same measurement type) or application.
135