Flowlink 5.1 Software Instruction Manual - Isco

Isco Flowlink 5.1 ® Software
Editor Window
default timespan specified by the Utilities>Options
settings.
• Graph the data. Then right-click on the graph and
select the Edit option to enable the Editor.
Alternatively, you can click the Edit/View
toolbar button to enable the editor. The Editor
window displays the timespan specified by the graph
properties.
2. Locate the incorrect data and highlight it. Using default
settings, Flowlink can edit up to 1439 readings (a day of
readings at one-minute intervals) at a time. The number
of readings can be increased or decreased as needed from
the Utilities>Options window.
3. Using the Type pull-down list on the Editor toolbar,
Determine the type of reading adjustment that will be
necessary.
• Constant value - changes all of the highlighted
readings to a single value.
• Fixed offset - increases or decreases the highlighted
readings by a fixed amount.
• Proportional - distributes an adjustment
proportionately over selected readings.
• Multiply by Constant Value - multiplies the readings
by a specified constant value. Specify a value greater
than 1 to increase the readings; less than 1 to
decrease the readings.
• Auto Correct - When selected, Flowlink will adjust
the highlighted readings to fit adjacent readings.
Because the amount is calculated by Flowlink, the
Amount value is not needed.
• Time (minutes) - shifts the highlighted times forward
or backward a fixed amount.
• Restore to Original - removes any corrections made to
the readings to restore it to the original data.
4. Enter the Amount.
5. Click Adjust. Flowlink changes the data according to the
Type and Amount. The new readings are displayed on
the table. The graph shows both the original and the new
readings. Default line colors can be specified on the
Utilities>Options window.
6. Click Save Changes.
Sometimes you may find that a combination of adjustment types
may work best to produce the desired results. Repeat the steps
above to apply additional adjustments.
134