Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
Flowlink 5.1 Software Instruction Manual - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Isco</strong> <strong>Flowlink</strong> <strong>5.1</strong> ® <strong>Software</strong><br />
Editor Window<br />
Notes:<br />
• The graph will always adjust its display to show all of the<br />
readings over the timespan. However, the table may not<br />
always be able to do so. The table is limited to the<br />
number of readings specified by the Utilities>Options<br />
setting. When the table cannot display all of the readings<br />
over the full timespan visible in the graph, the table can<br />
be advanced to the next page of data by selecting the first<br />
or last row of table data.<br />
• It is possible for the graph to contain many more selected<br />
points than the table can show. However the Editor will<br />
still apply adjustments to all selected data.<br />
• The graph displays the original and edited readings<br />
graphed as different colors. The table lists edited and<br />
original values for each point.<br />
Editor - Specific<br />
Date/Time...<br />
Editor - Making<br />
Adjustments<br />
To open the Enter Display Date/Time, select Actions>Go<br />
To>Specific Date/Time... from the <strong>Flowlink</strong> menu while the<br />
Editor window is open.<br />
Use this window to jump to a time/date. The entries you make in<br />
this window will be applied to the Editor window that is<br />
currently active.<br />
Steps:<br />
1. Enter the Start Date. Type the date (for example, “3/1/<br />
05”), or click on the pull-down arrow to select the date<br />
from a calendar.<br />
2. Enter the Start Time. Type in the hour, minute, and “A”<br />
(AM) or “P” (PM). Or, highlight the value to change and<br />
click on the Up or Down arrows.<br />
The graph and the table of readings in the Editor window will<br />
jump to the Start Date and Time. The graph and table will<br />
display all the readings that occur during the timespan.<br />
Reading adjustments may be needed for several reasons. Some<br />
examples are:<br />
• To correct erroneous readings caused by mis-calibrated<br />
sensors<br />
• To fill in gaps caused by power outages, signal loss, etc.<br />
• Clock changes<br />
• Memory partition changes<br />
To adjust the data:<br />
1. Open the data set for editing. There are two ways to do<br />
this:<br />
• Highlight the data set in the workspace and click the<br />
Edit Data set button (or the Item>Edit menu<br />
command). The Editor window will display the<br />
133