User manual - JG Technologies

Symbol
Description
Power steering active.
Wind Vane mode is active.
6.19 Initial set up procedures
Once your display has been installed and commissioned (see
Installation instructions), Raymarine recommends that you perform
an initial set up procedure.
Start-up wizard
When you power-up the display for the first time a Start-up Wizard
is displayed. The wizard guides you through the following initial
settings:
• Language selection.
• Boat type selection.
• Units configuration.
Note: These settings can also be made at any time using the
menus accessible from Homescreen > Customize.
Additional settings
In addition to the settings covered by the Wizard, it is also
recommended that the following initial set up tasks are completed:
• Set minimum safe depth.
• Set your date and time preferences.
• Adjust the display brightness (and set up a shared brightness
scheme if appropriate).
• Align the touchscreen (HybridTouch displays only).
• Designate the data master.
• Select the GPS data source.
• Familiarize yourself with the Simulator Mode.
Setting the vessel minimum safe depth
You can change the appearance of the vessel in the chart
application.
With the homescreen displayed:
1. Select Customize.
2. Select Boat Details.
3. Select Minimum Safe Depth.
4. Use the rotary to adjust the setting as appropriate. The units
for the depth measurement are based on those specified in
the Homescreen > Customize > Units Set-up > Depth Units
menu.
Setting time and date preferences
With the homescreen displayed:
1. Select Customize.
2. Select Time and Date Set-up.
3. Use the Date Format, Time Format, and Local Time: UTC
menu items to set your time and date preferences.
Adjusting the display brightness
1. Press the POWER button once.
The Backlight Level control is displayed.
2. Using the rotary control, adjust the brightness level as
appropriate.
Getting started 73