User manual - JG Technologies

6.3 c95 / c97 / c125 / c127 / e95 / e97 /
e125 / e127 Controls
UniControl
1 2 3
1
4
5
6
7
8
11 10
9
2
D12276-1
1. Touchscreen — you can touch the screen to operate many
common functions, including all menu operations (HybridTouch
multifunction displays only).
2. Home — Press to return to the homescreen.
3. Menu — accesses menus. Press again to close menus.
4. UniControl — provides a joystick and rotary control and an OK
button for using menus and applications.
5. Back — press to return to a previous menu or dialog level.
6. Range In/Out — Press minus (-) to range out and plus (+) to
range in
7. WPT / MOB — press and release to access the waypoint
options. Press again to place a waypoint. Press and hold to
place a Man Overboard (MOB) marker at your current position.
8. Power — press once to switch the unit ON. Once powered on,
press the Power button again to adjust the brightness, access
the power controls for external devices, and access the autopilot
controls. Press and hold to switch the unit OFF.
9. Chart card slots — open the card door to insert or remove
MicroSD cards. There are 2 card slots (labelled 1 and 2), used
for electronic charts and archiving waypoint, route and track
data.
10. Standby (Auto) — Press to disengage integrated autopilot,
press and hold to activate Auto mode on integrated autopilot.
11. Switch Active Pane — Press to switch active datapane..
3
D12180-1
1. Rotary — use this to select menu items, move the on-screen
cursor, and adjust the range in the chart and radar applications.
2. Joystick — use this to move the cursor position in applications,
pan up, down, left and right in the chart, weather and fishfinder
applications or to cycle through datapages in the data
application.
3. OK button — push the end of the joystick to confirm a selection
or entry.
Touch icons
You can use the BACK and CLOSE icons to move between the
different levels of menus available in each application.
This only applies to HybridTouch displays.
Back — go back one level (same effect as BACK button).
Close — close all open menus (same effect as holding the MENU
button for 3 seconds).
Using the cursor
The cursor is used to move around the screen.
The cursor appears on the screen as a white cross.
D7366_3
D7368_2
If the cursor has not been moved for a short period of time,
it changes to a circle with a cross in it, to make it easier to
locate on the screen.
Getting started 59