User manual - JG Technologies

Product dimensions
C
5.2 Removing the rear bezel
You must remove the rear bezel before flush-mounting the display.
1. Remove the front bezel. Refer to the separate instructions
provided for that procedure.
E
B
3
A
D
D12269-1
Item
e7 / e7D
e95 / e97 / c95 /
c97
A 233 mm (9.17 in.) 290 mm (11.42
in.)
e125 / e127 /
c125 / c127
354 mm (13.94
in.)
B 144 mm (5.67 in.) 173 mm (6.81 in.) 222 mm (8.74 in.)
C 64 mm (2.52 in.) 64 mm (2.52 in.) 69 mm (2.72 in.)
D 160 mm (6.29 in.) 160 mm (6.29 in.) 160 mm (6.29 in.)
E 180 mm (7.09 in.) 212 mm (8.35 in.) 256 mm (10.08
in.)
* = e7 / e7D
1
= c95 / c97 c125 / c127 / e95 / e97 / e125 / e127
*2
D12184-2
2. Remove the screws that secure the bezel to the display.
3. Carefully remove the bezel from the rear of the display, pulling
the bezel gently along the:
i. Outer edges - work from the sides upwards and then along
the top edge, ensuring that the clips are fully released from
the display.
ii. Inner edges - ensure that the bezel is completely removed
from the display.
Location and mounting 53