User manual - JG Technologies

More documents

Recommendations

Info

24.1 Service and maintenance This product contains no user serviceable components. Please refer all maintenance and repair to authorized Raymarine dealers. Unauthorized repair may affect your warranty. 24.2 Routine equipment checks Raymarine strongly recommends that you complete a number of routine checks to ensure the correct and reliable operation of your equipment. Complete the following checks on a regular basis: • Examine all cables for signs of damage or wear and tear. • Check that all cables are securely connected. 236 e7 / e7D / e95 / e97 / e125 / e127 / c95 / c97 / c125 / c127
24.3 Cleaning Best cleaning practices. When cleaning this product: • Do NOT wipe the display screen with a dry cloth, as this could scratch the screen coating. • Do NOT use abrasive, or acid or ammonia based products. • Do NOT use a jet wash. 24.4 Cleaning the display case The display unit is a sealed unit and does not require regular cleaning. If it is necessary to clean the unit, follow this basic procedure: 1. Switch off the power to the display. 2. Wipe the display with a clean, soft cloth (a microfibre cloth is ideal). 3. If necessary, use isopropyl alcohol (IPA) or a mild detergent to remove grease marks. Note: Do NOT use IPA or any other solvent or detergent on the screen itself. Note: In certain conditions, condensation may appear inside the display screen. This will not harm the unit, and can be cleared by powering on the display for a short time. Maintaining your display 237
Page 1:
e 7 / e 7 D / e 9 5 / e 9 7 / e 1 2
Page 5 and 6:
Contents Chapter 1 Important inform
Page 7 and 8:
20.4 Camera setup .................
Page 9 and 10:
Chapter 1: Important information Wa
Page 11 and 12:
Industry Canada (Français) Cet app
Page 13 and 14:
Chapter 2: Handbook information Cha
Page 15 and 16:
2.3 Handbook illustrations The illu
Page 17 and 18:
Chapter 3: Planning the installatio
Page 19 and 20:
Item Device Type Maximum quantity S
Page 21 and 22:
Item Device Type Maximum quantity S
Page 23 and 24:
3.4 Multiple data sources (MDS) ove
Page 25 and 26:
3.7 Typical systems SMMART TPIL LOT
Page 27 and 28:
3.8 System protocols Your Multifunc
Page 29 and 30:
3.11 Parts supplied 3.12 Tools requ
Page 31 and 32:
Chapter 4: Cables and connections C
Page 33 and 34:
4.3 Power connection Power cable Th
Page 35 and 36:
4.4 Network connections You can con
Page 37 and 38:
Digital radar cable extension For l
Page 39 and 40:
Sonar variant multifunction display
Page 41 and 42:
4.7 Fastheading connection If you w
Page 43 and 44:
4.9 SeaTalk connection You can conn
Page 45 and 46:
Item Device Cable color Port Input
Page 47 and 48:
4.13 Video in-out connection A vide
Page 49 and 50:
4.15 WiFi connections Video streami
Page 51 and 52:
Chapter 5: Location and mounting Ch
Page 53 and 54:
Product dimensions C 5.2 Removing t
Page 55 and 56:
5.5 Bracket (trunnion) mounting The
Page 57 and 58:
Chapter 6: Getting started Chapter
Page 59 and 60:
6.3 c95 / c97 / c125 / c127 / e95 /
Page 61 and 62:
6.5 Hybridtouch overview Your multi
Page 63 and 64:
2 5. Select Radar. 6. Select the Tr
Page 65 and 66:
In some circumstances it may be bet
Page 67 and 68:
6.12 Pages Pages are used to displa
Page 69 and 70:
Screen item Description 1 Back —
Page 71 and 72:
6.16 Editing Numerical values in di
Page 73 and 74:
Symbol Description Power steering a
Page 75 and 76:
Chapter 7: Managing display data Ch
Page 77 and 78:
7.3 Removing a memory card or chart
Page 79 and 80:
Application Setting Affected System
Page 81 and 82:
7.5 Resetting your system Your syst
Page 83 and 84:
Chapter 8: Using waypoints, routes
Page 85 and 86:
Waypoint features There are a range
Page 87 and 88:
Symbol Type Symbol Type Fish (1-sta
Page 89 and 90:
1. Select and hold a location on sc
Page 91 and 92:
1. Select Menu. 2. Select My Data.
Page 93 and 94:
• From the chart application, sel
Page 95 and 96:
Chapter 9: Using the chart Chapter
Page 97 and 98:
Navionics chartplotter sync connect
Page 99 and 100:
Auto Range selects and maintains th
Page 101 and 102:
9.4 Chart context menu Placing the
Page 103 and 104:
9.8 Chart vectors Chart vectors dis
Page 105 and 106:
9.10 Tide information Animated tide
Page 107 and 108:
9.12 Chart presentation The chart h
Page 109 and 110:
Enabling centre of view To enable t
Page 111 and 112:
Chart set-up menu options The follo
Page 113 and 114:
Menu item Description Options Nav.
Page 115 and 116:
Chapter 10: Using autopilot control
Page 117 and 118:
10.2 Autopilot status symbols The a
Page 119 and 120:
Chapter 11: Using alarms and MOB fu
Page 121 and 122:
11.2 Alarms Alarms alert you to a s
Page 123 and 124:
Menu item Description Options Guard
Page 125 and 126:
Chapter 12: Using radar Chapter con
Page 127 and 128:
12.2 Digital radar scan speed Super
Page 129 and 130:
Blind Sectors Obstructions such as
Page 131 and 132:
Scanner Dual Range mode Operating m
Page 133 and 134:
12.8 Radar adjustments: HD and Supe
Page 135 and 136:
12.9 Radar adjustments: non-HD digi
Page 137 and 138:
Function Description Options Data O
Page 139 and 140:
D12214-1 D12215-1 D12216-1 VRM/EBL
Page 141 and 142:
1. Select the guard zone. The guard
Page 143 and 144:
2. Press the Ok button The MARPA co
Page 145 and 146:
12.14 Resetting the radar To reset
Page 147 and 148:
Chapter 13: Using AIS Chapter conte
Page 149 and 150:
13.2 AIS prerequisites You must hav
Page 151 and 152:
13.6 AIS status symbols AIS status
Page 153 and 154:
13.10 Viewing all AIS targets From
Page 155 and 156:
13.13 AIS alarms The AIS functions
Page 157 and 158:
Chapter 14: Using the fishfinder Ch
Page 159 and 160:
14.2 The sonar image Interpreting t
Page 161 and 162:
14.5 Fishfinder preset configuratio
Page 163 and 164:
14.7 Fishfinder range The Range and
Page 165 and 166:
6. Press the Ok button, or select t
Page 167 and 168:
14.11 Fishfinder scrolling The fish
Page 169 and 170:
14.14 Sounder set-up menu options T
Page 171 and 172:
14.16 Resetting the sonar The reset
Page 173 and 174:
Chapter 15: Using the data applicat
Page 175 and 176:
Datapage Default Data Items Engine
Page 177 and 178:
Data Category Data Item Digital Dia
Page 179 and 180:
Chapter 16: Using the weather appli
Page 181 and 182:
16.3 Weather application display ov
Page 183 and 184:
Color code Precipitation type Refle
Page 185 and 186: 16.6 Weather information You can vi
Page 187 and 188: 16.9 Weather application menu optio
Page 189 and 190: Term Wave cyclone Wave period Defin
Page 191 and 192: Chapter 17: Using video Chapter con
Page 193 and 194: Chapter 18: Wireless video streamin
Page 195 and 196: 18.3 Enabling display streaming Dis
Page 197 and 198: Chapter 19: Media player applicatio
Page 199 and 200: 19.3 Pairing a Bluetooth media play
Page 201 and 202: 19.7 Unpairing a Bluetooth device I
Page 203 and 204: Chapter 20: Using the thermal camer
Page 205 and 206: 20.2 Camera control Thermal camera
Page 207 and 208: Enabling thermal camera rear view m
Page 209 and 210: Chapter 21: DSC VHF radio integrati
Page 211 and 212: Chapter 22: Using a remote control
Page 213 and 214: 22.3 Operating principles Remote co
Page 215 and 216: 22.6 Reconnecting the RCU 1. When y
Page 217 and 218: Chapter 23: Customizing your displa
Page 219 and 220: 23.2 Boat details You can customize
Page 221 and 222: 23.4 Time and Date set-up You can s
Page 223 and 224: 23.6 Data cell and databar customiz
Page 225 and 226: Data category Description Options E
Page 227 and 228: Alarms menu Menu item Description O
Page 229 and 230: Ground trip resets menu This menu e
Page 231 and 232: Menu item Description Options Conne
Page 233 and 234: Menu item Description Options Note:
Page 235: Chapter 24: Maintaining your displa
Page 239 and 240: Chapter 25: Troubleshooting Chapter
Page 241 and 242: 25.2 Power up troubleshooting Probl
Page 243 and 244: 25.4 GPS troubleshooting Problems w
Page 245 and 246: 25.6 Thermal camera troubleshooting
Page 247 and 248: 25.8 Video troubleshooting Problems
Page 249 and 250: 25.10 Bluetooth troubleshooting Asp
Page 251 and 252: 25.12 Miscellaneous troubleshooting
Page 253 and 254: Chapter 26: Technical support Chapt
Page 255 and 256: Chapter 27: Technical specification
Page 257 and 258: Resolution Viewing angle 800 x 480
Page 259 and 260: Chapter 28: Spares and accessories
Page 261 and 262: 28.3 e7 e7D spares Item Part number
Page 263 and 264: 28.7 e125 / e127 / c125 / c127 spar
Page 265 and 266: Appendix A NMEA 0183 sentences The
Page 267 and 268: Appendix C Connectors and pinouts P
Page 270: www.raymarine.com
show all

User manual - JG Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?