User manual - JG Technologies

Data
Category Data Item Digital Dial Graphical
Time
Wind
None
Local Time
Local Date
TWS & TWA
AWS & AWA
GWS & GWD
VMG to
Windward
Note: The engine data category shown above will contain one
set of data items per engine.
Renaming a datapage
From the data application:
1. Select Menu.
2. Select Edit Page.
3. Select Rename Page.
The on screen keyboard is displayed.
4. Enter the new name for the datapage.
5. Select SAVE.
Adding a new datapage
You can add your own customized datapages to the data application.
The total number of datapages including pre-configured pages is 10.
From the data application:
1. Select Menu.
2. Select Create New Page.
A list of available page layouts is displayed.
3. Select the required page layout.
The new page is displayed on screen.
Deleting a datapage
You can delete custom or pre-configured datapages from the data
application. The minimum number of datapages allowed is 1.
From the data application:
1. Scroll to the datapage you want to delete.
2. Select Menu.
3. Select Delete Page.
The confirm delete pop up message is displayed.
4. Select Yes to delete the datapage, or No to cancel the action.
Note: You cannot create a new engine page with the same layout
as the pre-configured engine datapages.
Setting number of engines
You can set the number of engines your vessel has between 1 and 3.
From the data application:
1. Select Menu.
2. Select Num. Of Engines.
3. Select either 1, 2 or 3.
Once selected, a tick will be placed next to the item in the menu
and the engine datapage will be reset to display the correct
number of engines.
Engine datapages
Depending on the number of engines you choose you will see one
of the following datapages:
1 Engine
2 Engines
3 Engines
Note: The default number of engines is determined by the
vessel type selected during the initial start up wizard, if a sail
boat is chosen then default is 1 engine for motor boats default
is 2 engines.
4. Select the blank cell on the new page layout that you want to
add a data item to.
5. Select Select Data Category.
6. Select a data category.
Selecting a data category will display a list of data items for
that category.
7. Select the data item you want to display.
Once selected a tick will be placed next to the data item in the
menu and the cell on screen will display the selected data item.
8. Repeat steps 3 to 6 for all the data items you want to change.
9. Select Rename Page.
The on screen keyboard is displayed.
10.Enter the new name for the datapage.
11. Select SAVE.
Setting maximum engine RPM
You can set the maximum RPM range to display on the RPM data
item.
From the data application:
1. Select Menu.
2. Select Max RPM Range.
A list of available RPM settings is displayed.
3. Select the required RPM range.
A tick will be placed next to the selected RPM range in the menu
and the RPM range on the engine datapage will be changed to
your new setting.
Using the data application 177