User manual - JG Technologies
User manual - JG Technologies
User manual - JG Technologies
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
14.3 Fishfinder presets<br />
The fishfinder provides you with four preset configurations available<br />
from the fishfinder menu. These enable you to quickly select<br />
appropriate settings tailored for various situations.<br />
Each preset has been configured to provide the best operating<br />
parameters for the fishfinder. However, it is possible to <strong>manual</strong>ly<br />
adjust the presets if necessary. The four default presets are:<br />
• Single — this preset provides quick access to a single-frequency<br />
configuration, suitable for general fishing conditions.<br />
• Dual — this preset provides a dual frequency configuration.<br />
You can either display two different frequencies at the same<br />
time in one window, or display one frequency at full-screen on<br />
your master display and the other frequency at full-screen on an<br />
additional networked display.<br />
• Shallow — this preset optimizes the fishfinder display for shallow<br />
waters.<br />
• Deep — this preset optimizes the fishfinder display for deep<br />
waters.<br />
14.4 Dual / Single frequency fishfinder<br />
Dual frequency operation allows the sonar to operate and display 2<br />
frequencies simultaneously. If the preset mode that you are using<br />
has two frequencies configured, you can view either one or both of<br />
those frequencies in separate windows.<br />
Selecting dual frequency view<br />
From the fishfinder application:<br />
1. Select Menu.<br />
2. Select Select Preset.<br />
3. Select Dual.<br />
4. Select View.<br />
5. Select the required setting:<br />
• Frequency 1<br />
• Frequency 2<br />
• Both<br />
Display modes<br />
When using presets, you can either select the relevant preset and<br />
start using the default configuration immediately, or you can adjust<br />
and configure frequencies:<br />
• Zoom<br />
• Bottom Lock<br />
• A-Scope<br />
Any changes you make to a preset are retained when you switch<br />
off the power to your multifunction display.<br />
Selecting a fishfinder preset<br />
From the fishfinder application:<br />
1. Select Menu.<br />
2. Select Select Preset.<br />
3. Select the required preset.<br />
The fishfinder display will change to the new mode. This is indicated<br />
in the top left-hand corner of the status bar.<br />
160 e7 / e7D / e95 / e97 / e125 / e127 / c95 / c97 / c125 / c127