SiLabs Si2400 - Connect One

More documents

Recommendations

Info

Reference Design Figure 3. SL-IERB Application Circuit Schematic Page 8 July 2001
Reference Design Appendix A Configuring iChip to Operate with Silicon Labs’ Si2400 ISOmodem +iMTYP - Set type of modem connected to iChip Syntax: AT+iMTYP=n Set the modem type Parameters: n = 0 .. 2 Command Options: n = 0 n = 1 n = 2 Standard, Hayes compatible, dial-up modem Silicon Laboratories Si2400. See note below. GSM modem Default: n = 0 Standard, Hayes compatible Scope: Result code: iChip. I/OK If n is within limits. I/ERROR Otherwise. AT+iMTYP? Returns current modem type designator. The reply is followed by I/OK. AT+iMTYP=? Returns the message "0-2". The reply is followed by I/OK. Note: Configure the iChip to work with the Silicon Laboratories Si2400 as follows: 1. AT+iMTYP=1 2. AT+iMIS='AT' 3. AT+iBDRF=3 4. AT+iBDRM=3 …Excerpt from the AT+i Programmer’s Manual Page 9 July 2001
Page 1 and 2: Reference Design SL-IERB Internet-E
Page 3 and 4: Reference Design Pin Descriptions:
Page 5 and 6: Reference Design Changes Required o
Page 7: Reference Design Bill of Materials

SiLabs Si2400 - Connect One

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?