SiLabs Si2400 - Connect One
SiLabs Si2400 - Connect One SiLabs Si2400 - Connect One
Reference Design SL-IERB Daughterboard Layout: Rev. 1.00 SiLAB1 To Si2400 EVB JP3 / JP7 iChip CO561AD-S Page 4 July 2001
Reference Design Changes Required on Si2400URT-EVB REV 3.0 Board: The Si2400 board must undergo several changes in order to support Connect One’s SL-IERB adapter. See Figure 2. Following is a list of the required changes: • Remove R56 AND R54 • Add 0O resistors on R55 and R57 • Make sure R53 is unpopulated • Make sure R52, R58 and R59 are populated with 0O resistors • Install jumpers JP5 and JP6 • Remove jumper JP2 pin 8 • Remove jumper JP2 pin 11 • Assemble a low profile oscillator on X1 Note : The SL-IERB adapter works only with the Si2400URT-EVB REV 3.0 board. Page 5 July 2001
- Page 1 and 2: Reference Design SL-IERB Internet-E
- Page 3: Reference Design Pin Descriptions:
- Page 7 and 8: Reference Design Bill of Materials
- Page 9: Reference Design Appendix A Configu
Reference Design<br />
SL-IERB Daughterboard Layout:<br />
Rev. 1.00<br />
SiLAB1<br />
To <strong>Si2400</strong> EVB JP3 / JP7<br />
iChip<br />
CO561AD-S<br />
Page 4<br />
July 2001