AT Commands Set

SIM5320 AT Command Set
OK
$GPGSV,4,1,16,04,53,057,44,02,55,334,44,10,61,023,44,05,45,253,43*7D
$GPGSV,4,2,16,25,10,300,40,17,25,147,40,12,22,271,38,13,28,053,38*77
$GPGSV,4,3,16,26,09,187,35,23,06,036,34,24,,,,27,,,*7A
$GPGSV,4,4,16,09,,,,31,,,,30,,,,29,,,*7D
$GPGGA,051147.0,3113.320991,N,12121.248076,E,1,10,0.8,47.5,M,0,M,,*45
$GPVTG,NaN,T,,M,0.0,N,0.0,K,A*42
$GPRMC,051147.0,A,3113.320991,N,12121.248076,E,0.0,0.0,211211,,,A*66
$GPGSA,A,3,02,04,05,10,12,13,17,23,25,26,,,1.4,0.8,1.2*3B
21.18 AT+CGPSPMD Configure positioning mode
Description
The command is used to configure the positioning modes support.
NOTE Need to restart the module after setting the mode.
SIM PIN References
NO Vendor
Syntax
Test Command
AT+CGPSPMD=?
Read Command
AT+CGPSPMD?
Write Command
AT+CGPSPMD=
Responses
+CGPSPMD: (scope of )
OK
Responses
+CGPSPMD:
OK
Responses
OK
ERROR
Defined values
Range – 1 to 127, default is 127
Each bit enables a supported positioning mode as follows:
Bit 0 – Standalone
Bit 1 – UP MS-based
Bit 2 – UP MS-assisted
Bit 3 – CP MS-based (2G)
Bit 4 – CP MS-assisted (2G)
Bit 5 – CP UE-based (3G)
SIM5320_ATC_V1.24 473
8/14/2012