AT Commands Set

SIM5320 AT Command Set
1 – EDGE trigger mode
0 – trigger when low level
1 – trigger when high level
0 – not save the setting
1 – save the setting
NOTE If the parameter of is omitted, it will save the setting.
Examples
AT+CGPIO=1,1,0
OK
9.13 AT+CGDRT Set the direction of specified GPIO
Description
The command is used to set the specified GPIO to in or out state. If setting the specified GPIO to in
state, then it can not set the value of the GPIO to high or low.
SIM PIN
NO
References
Vendor
Syntax
Write Command
AT+CGDRT=,
[,]
Responses
OK
ERROR
Defined values
0 – GPIO0
2 – GPIO2
3 – GPIO3
5 – GPIO5
0 – in
1 – out
0 – not save the setting
1 – save the setting
NOTE If the parameter of is omitted, it will save the direction of specified GPIO.
SIM5320_ATC_V1.24 198
8/14/2012