CLIOwin 6.5 PCI User's Manual - Audiomatica Srl

More documents

Recommendations

Info

7.6 THE MLS TIME DOMAIN DISPLAY When entering the MLS time domain you will find a slightly different display (Fig. 7.2). Figure 7.2 In this case there are no overlays. It is also possible to select a portion of the active curve by means of three particular buttons. The selected portion of the active curve is identified by a start and stop point and is draw in a different color from the unselected portion. Defines the start point of the selection. Defines the stop point of the selection. Returns the curve to a completely unselected state. 68 Chapter 7 - Common Measuring Interface
8 MULTI-METER 8.1 INTRODUCTION The Multi-meter is an interactive, real-time, measuring instrument. It gives <strong>CLIOwin</strong> the functionality of a: - Sound level meter (dBSPL, dBA, dBC) - Millivoltmeter (V, dBV, dBu, dBr) - Frequency counter (Hz) - Distortion meter (%, dB) - L-C-R bridge (H, uF, Ohm) Recallable simply pressing F4, the Multi-meter has also the capability of controlling the generator and of capturing the global reference level; thus it can be considered the heart and control center of CLIO; it is rare that you enter <strong>CLIOwin</strong> and don't use the Multi-meter, the information and controls available here are of invaluable importance during the normal operation of the whole instrument. 8.2 MULTI-METER CONTROL PANEL Figure 8.1 Multi-meter control panel Chapter 8 - Multi-Meter 69
Page 1 and 2:
ELECTRICAL & ACOUSTICAL TESTS User'
Page 3 and 4:
CONTENTS 1 INTRODUCTION ...........
Page 5 and 6:
8.5.1 MEASURING AN INDUCTOR .......
Page 9:
1 INTRODUCTION 1.1 ABOUT THIS MANUA
Page 12 and 13:
12 Chapter 1 - Introduction
Page 14 and 15:
2.1 THE PB-4281 PC BOARD AND SC-01
Page 16 and 17:
2.2.3 THE MIC-01 (OR MIC-02) FREQUE
Page 18 and 19: 2.4 THE QCBOX MODEL 4 AMPLIFIER & S
Page 20 and 21: Figure 3.1 2) 2 x Stereo mini jack
Page 22 and 23: 3.3 HARDWARE REGISTRATION WITH WIND
Page 24 and 25: 3.3.2 HARDWARE REGISTRATION UNDER W
Page 26 and 27: 3.3.3 HARDWARE REGISTRATION UNDER W
Page 28 and 29: Figure 3.21 Let's now verify that t
Page 30 and 31: 3.4 SOFTWARE INSTALLATION This para
Page 32 and 33: 3.6 RUNNING CLIOWIN FOR THE FIRST T
Page 34 and 35: 3.7.1 CALIBRATION VALIDATION Figure
Page 36 and 37: 36 Chapter 3 - Installation
Page 38 and 39: 38 Chapter 4 - Troubleshooting CLIO
Page 40 and 41: 5.3 CLIOWIN DESKTOP The CLIOwin des
Page 42 and 43: It is possible to generate the foll
Page 44 and 45: Fig.5.5 Microphone sensitivity dial
Page 46 and 47: 5.5.2 CONTROLLING A TURNTABLE Fig.5
Page 48 and 49: 5.6.2 ANALYSIS MENU The Analysis me
Page 50 and 51: H Enables the Hold function. Equiva
Page 52 and 53: CTRL+P Swithces on and off the micr
Page 54 and 55: 5.7.2 CONNECTING A MICROPHONE For a
Page 56 and 57: 56 Chapter 5 - CLIOwin basics
Page 58 and 59: When you find a CLIOwin data file i
Page 60 and 61: Enters the Notes dialog where it is
Page 62 and 63: 6.3.5 CALIBRATION File > Calibratio
Page 64 and 65: 6.3.7 STARTUP OPTIONS AND GLOBAL SE
Page 66 and 67: 7.3 BUTTONS AND CHECKBOXES Moves (s
Page 70 and 71: 8.2.1 TOOLBAR BUTTONS Starts the me
Page 72 and 73: This operating mode is very useful;
Page 74 and 75: Figure 8.7 With the Multi-meter run
Page 76 and 77: 76 Chapter 8 - Multi-Meter
Page 78 and 79: 9.2.1 TOOLBAR BUTTONS Starts an FFT
Page 80 and 81: 9.4 FFT AND RTA OPERATION The FFT a
Page 82 and 83: 9.5 AVERAGING Averaging plays a ver
Page 84 and 85: 9.6 TIME DATA DISPLAY (OSCILLOSCOPE
Page 86 and 87: 10.2.1 TOOLBAR BUTTONS Starts an ML
Page 88 and 89: 10.2.4 MLS POST-PROCESSING TOOLS Lo
Page 90 and 91: 10.4 MEASURING FREQUENCY RESPONSE I
Page 92 and 93: 150.0 CLIO 180.0 150.0 CLIO 180.0 O
Page 94 and 95: MLS Menu, select dBSPL as Y scale u
Page 96 and 97: 10.4.4 PHASE & GROUP DELAY We used
Page 98 and 99: 110.0 CLIO 7.50 dBSPL ms 100.0 6.00
Page 100 and 101: 10.5 OTHER TIME DOMAIN INFORMATION
Page 102 and 103: utton. Any process you execute can
Page 104 and 105: 104 Chapter 10 - MLS
Page 106 and 107: 11.2.1 TOOLBAR BUTTONS Starts the s
Page 108 and 109: Stepped is also not checked. Typica
Page 110 and 111: 11.3 A BRIEF DESCRIPTION ON SETTING
Page 112 and 113: 11.3.3 GATING Enabling Gating allow
Page 114 and 115: 11.4 DISTORTION AND SETTINGS Sinuso
Page 116 and 117: Finally Fig.11.12 shows the distort
Page 118 and 119:
12.3 WATERFALL BASICS Figure 12.2 W
Page 120 and 121:
12.4 MAKING A CUMULATIVE SPECTRAL D
Page 122 and 123:
Let's now change the CSD aspect aga
Page 124 and 125:
Figure 12.11 12.5.3 TAKING THE MEAS
Page 126 and 127:
Figure 12.17 The final result for o
Page 128 and 129:
If you are novice in using CLIO or
Page 130 and 131:
-10.0 CLIO dBV -30.0 -50.0 -70.0 -9
Page 132 and 133:
13.4 I SENSE Requires Audiomatica C
Page 134 and 135:
Figure 13.12 Lets proceed now with
Page 136 and 137:
The figure shows us we are going to
Page 138 and 139:
13.7 THIELE & SMALL PARAMETERS 13.7
Page 140 and 141:
L 1kHz L 10kHz Inductance at 10kHz
Page 142 and 143:
Now we can save our complete result
Page 144:
[19] M.O. Hawksford, “Digital Sig
show all

CLIOwin 6.5 PCI User's Manual - Audiomatica Srl

Create successful ePaper yourself

Delete template?

Save as template?