CLIOwin 6.5 PCI User's Manual - Audiomatica Srl

emoved at any moment after the measurement has been taken.
11.2.3 SINUSOIDAL SETTINGS DIALOG
It is undoubtedly the most important User Interface of the entire Menu. Here the single
action of every control is considered. Theoretical and practical effects on the subsequent
measurement are considered later.
Sweep Settings
Stepped Check Box
Lets the user choose between continuous or stepped Logarithmic Sweep. Continuous
sweep is faster but, therefore, should be used only if its clear to the user how
this affects the measure.
Resolution Drop Down
Lets the user choose between five different Frequency resolutions. It affects the
measurement execution time, whatever are the other settings.
Freq Max Edit Box
Lets the user define the highest Frequency of the Sweep. This is also the starting
measurement Frequency. The highest value accepted is 22388 Hz. The value should
also be one octave higher than the Minimum Frequency.
Freq Min Edit Box
Lets the user define the lowest Frequency of the Sweep. This is also the end
measurement Frequency. The lowest value accepted is 10 Hz. The value should also
be one octave lower than the Maximum Frequency.
Gating (Acquisition) Settings
Gated Check Box
Lets user enable the gating acquisition mode. Checking it will automatically disable
the Stepped Check Box and check it. That is, Gated Measurements are always carried
in Stepped Mode.
Delay Edit Box
Lets user define the delay, in ms, applied between the signal generation and its
acquisition. When different than 0 it is active, even when gating is not checked, if
Chapter 11 - Sinusoidal 107