J2 680 Integrated Touchscreen Computer System Manual - Size

More documents

Recommendations

Info

Service Removing the Head from the Base The 680 is shipped with a counter top base which allows for the head to be adjusted from 0-90°. To remove the integrated head from the base, fully loosen the thumbscrew located on the back of the unit under the hinge of the counter top base, as shown below. Then lift the head as illustrated: Loosen Thumb Screw Slide Head up to remove J2 680 System Manual Version 1.0 May 11, 2012 26
Removing the Power Supply The power supply is normally located in the counter top base. When using a wall mount bracket or the J2 UPS, the power supply would be external from the unit. To remove the power supply from the base, three screws needs to be removed as shown. Screw locations J2 680 System Manual Version 1.0 May 11, 2012 27
Page 1 and 2: J2 680 Integrated Touchscreen Compu
Page 3 and 4: Contents Overview .................
Page 5 and 6: F6 Installation Method ............
Page 7 and 8: J2 680 System Manual Version 1.0 Ma
Page 9 and 10: Power Power Adapter 19VDC, 180W, 10
Page 11 and 12: UPS Not your ordinary UPS, the J2 6
Page 13 and 14: Processors currently supported on t
Page 15 and 16: Hard Disks Two 2.5 inch SATA hard d
Page 17 and 18: The 680 also supports the newer dig
Page 19 and 20: USB Ports The 680 has six external
Page 21 and 22: Audio The 680 uses the VIA1708B HD
Page 23 and 24: Cash Drawer Controller Register The
Page 25: Typical Power Consumption 680 The t
Page 29 and 30: Optional Wall Mount Bracket Install
Page 31 and 32: Changing the System Board *Special
Page 33 and 34: Adding Memory Note: An anti-static
Page 35 and 36: BIOS Setup Entering the BIOS Setup
Page 37 and 38: SATA Configuration In this screen t
Page 39 and 40: Power Configure Screen Power Config
Page 41 and 42: Exit Options After making any chang
Page 43 and 44: Audio Driver Installation The Audio
Page 45 and 46: Resistive Touch Screen Driver Insta
Page 47 and 48: Multi-Touch Projected Capacitive To
Page 49 and 50: Optional Multi-Touch Projected Capa
Page 51 and 52: OPOS drivers The OPOS driver for th
Page 53 and 54: As can be seen above, when running
Page 55 and 56: SMI BIOS Info Utility The J2 SMI BI
Page 57 and 58: J2 Virtual Serial Ports Drivers Vir
Page 59 and 60: Enabling RAID in the BIOS The Intel
Page 61 and 62: If a hot spare is available, all th
Page 63 and 64: Packing List In addition to the foa
Page 65 and 66: Installing the 680 MSR The 680 MSR
Page 67 and 68: Customer Display Overview A 2 line
Page 69: Contact Information European Office

J2 680 Integrated Touchscreen Computer System Manual - Size

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?