ISP 24xx/25xx Firmware Release Notes - QLogic
ISP 24xx/25xx Firmware Release Notes - QLogic
ISP 24xx/25xx Firmware Release Notes - QLogic
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2.13 From 4.00.25 to 4.00.26<br />
Changes<br />
Error Report<br />
[ER48188]<br />
[ER48819]<br />
Description<br />
MID only. The firmware Interface has been extended to support up to 128 NPIV ports when connected to an F Port. The size of<br />
the Multiple ID Initialize <strong>Firmware</strong> Control block is now determined by the VP Count field (offset 80h-81h). The VP Count field will<br />
be in the range of 1-125 (for public loop or private loop topology) or 1-127 (for fabric F Port topology).<br />
<strong>Firmware</strong> used to reserve a minimum of 256 exchanges for internal use.<br />
[ER48210] SB2 only. PLOGI Common Service Parameters FC_PH Version High/Low from 20/20 to 20/09.<br />
[ER48834]<br />
[ER48203]<br />
[ER48178]<br />
[ER48360]<br />
[ER48511]<br />
SB2 only. Return OX_ID used for the Send SB2 IU IOCB for selected completion statuses. See SB2 <strong>Firmware</strong> Interface Spec<br />
version 1.9 for details.<br />
MID only. <strong>Firmware</strong> now sends a LOGO ELS to reserved ports FFFFFE and FFFFFC when a VP port is disabled. Also, the<br />
firmware now returns the VP Index in outgoing Mailbox 3 when receiving an RSCN.<br />
Added a Set Transmit Parameters (0019h) Mailbox Command option, which allows multiple transmit channels in loop mode. To<br />
enable this feature, set bit 4 of Incoming Mailbox Register 1 when issuing this Mailbox Command. Please refer to App Note, Set<br />
Transmit Parameters Mailbox Command for 2400 Series.<br />
When the Target PRLI Control option is set, the firmware sends a PRLI when configured for Target only operation and a PRLI<br />
was not received from the Initiator device. This option is enabled by setting bit 14 of <strong>Firmware</strong> Options 2 during Initialize <strong>Firmware</strong><br />
(0060h) Mailbox Command. This applies only when the <strong>ISP</strong> is directly connect to another N Port.<br />
Return Node Name / Port Name from received PLOGI/PDISC/ADISC in Immediate Notify IOCB. The Node Name is located at<br />
offset 20h-27h and the Port Name is located at offsets 28h-2Fh (both are in big-endian format). The firmware also returns the<br />
Port Name from a received LOGO payload in the Immediate Notify IOCB at offsets 28h-2Fh.<br />
<strong>ISP</strong> <strong>24xx</strong>/<strong>25xx</strong> <strong>Firmware</strong> <strong>Release</strong> <strong>Notes</strong> 12 of 15
Change language