Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Connecting the Imager with USB<br />
Note: Hand Held Products recommends connecting the imager end of the cable<br />
first and the host end second.<br />
An imager can be connected to the USB port of a computer.<br />
1. Connect the appropriate interface cable to the imager and to the computer.<br />
2. The imager beeps.<br />
3. Verify the imager operation by scanning a barcode from the Sample Symbols<br />
in the back of this manual.<br />
For additional USB programming and technical information, refer to the Hand<br />
Held Products “USB Application Note,” available at www.handheld.com.<br />
USB PC or Macintosh Keyboard<br />
The 3200 imagers are factory programmed for a USB interface. If this is your<br />
interface and you do not need to modify the settings, skip to Chapter 3.<br />
If you programmed the imager for a different terminal interface and you want to<br />
change to a USB Keyboard (PC) or USB Keyboard (Mac), scan one of the<br />
following codes to program the 3200. Scanning these codes adds a CR and<br />
selects the terminal ID (USB PC Keyboard - 124, USB Macintosh Keyboard -<br />
125).<br />
USB Keyboard (PC)<br />
USB Keyboard (Mac)<br />
1 - 2 3200 <strong>User</strong>’s Guide