Bluetooth Commands - wless.ru

Appendix B – Responses
Appendix B – Responses
Notes on Short Response Mode Structure:
• The first number (2-3 digits) returned identifies the command that was sent. All identifiers are unique to
each specific command except for commands such as ATSSN and ATSSNC. These have the same basic
function, only ATSSN is for point-to-point and ATSSNC is for multi-point use. In this case, the identifiers
will be the same.
• The second number (2 digits) returned after the comma is the response code. If the response code is 00
(“OK” in long response mode), then the command has been successfully received by the radio. This does
not mean the command is complete, but just that it has been accepted by the radio, as some commands
may not go into effect or return data immediately. Anything other than a 00 returned in the second
position means there was an error with the command.
• Any data returned after the second number will vary based on the command entered. See the response
table below for data formatting.
Response Table:
All example responses shown are with factory default settings in place. See AT Commands section for
description of returned parameters.
AT
Example Long Response
Example Short Response
Command
Attention Prefix
AT OK 107,00
Firmware Version
ATVER,ver1 OKVer 3.6.2.1.0.0 52,00,Ver 3.6.2.1.0.0
Resetting
ATURST No Response No Response
ATFRST OKRESET
COMPLETE
75,00RESET
COMPLETE
ERROR
75,01
ATSSW,0 OK 102,00
ERROR
102,01
ATRSW,0 OK0 103,00,00
Boot Mode
ATSSW,1 OK 102,00
ERROR
102,01
ATRSW,1 OK 103,00,00
Security Level
ATSSW,2 OK 102,00
ERROR
102,01
ATRSW,2 OK 103,00,00
Get Status
ATSI,1 OK00A09608F513 14,00,123456789012
ATSI,2 OKSocketWireless 53,00,0A,SocketWireless
ATSI,3 OK0,0 17,00,0,0
Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360G) 74