Bluetooth Commands - wless.ru

Chapter 4 – Examples
Example of a Slave Command Sequence
From Power Up
1. Perform an inquiry and search for Slave Bluetooth device with a PC or other embedded unit.
2. Send a connection request from PC or embedded device to the Slave.
3. Wait for a connection
Reply: CONNECT,{SLAVE ADDRESS} // SPP Connected
4. Send Data.
Note:
This command sequence assumes the SocketWireless is in factory default in which it automatically comes up
and is connectable as a Slave from a Master request.
Get Out of Data Mode and Check Status
1. Delay at least 50 milliseconds.
2. Check Status, perform a Disconnect …etc.
Sent : AT
Reply: OK
Examples of Server Applications
Headset Point-to-Point
Sent: ATSW25,0,1,0,0
Reply: OK
Sent:ATSSNC,0,Headset0,1108
Reply: OK
Sent: ATSC,00200404
Reply: OK
Sent: ATSW25,2,0,0,0
Reply: OK
// Sets connect mode to slave
// Sets service and name
// Sets COD to a known headset COD
// Sets no response mode
Headset Multipoint
Sent: ATSSW,3,4 // Sets connection number to 4
Reply: OK
Sent: ATSSNC,0,Headset0,1108 // Sets service and name
Reply: OK
Sent: ATSC,00200404
// Sets COD to a known headset COD
Reply: OK
Sent: ATSW25,2,0,0,0
// Sets no response mode
Reply: OK
Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360G) 62