Bluetooth Commands - wless.ru

Chapter 2 – AT Commands
Security PIN Settings Commands
SSW, 6 Set Pin Request Handling Mode
Sets the PIN (Personal Identification Number) request handling mode. If set to 0 the PIN stored
using the ATSP command will automatically be used during PIN exchanges. If set to 1 the
prompt “PIN REQUEST” will be output by the radio and the user will need to manually enter a PIN
using the ATPR command.
Format:
Parameters:
ATSSW,6,
Mode:
0 = Automatic PIN Request Handling
1 = Manual PIN Request Handling
Factory Default: 0
EXAMPLE:
TYPE: ATSSW,6,1
REPLY: OK
OR
ERROR
Read Using: ATRSW,6
Note: Requires a reset for change to take affect.
RSW,6 Read Pin Request Handling Mode
Reads the PIN request handling mode.
Format: ATRSW,6
Return Parameters:
EXAMPLE:
TYPE: ATRSW,6
REPLY: OK
00
Set Using: ATSSW,6
SP Set PIN
Sets the PIN to be used with automatic PIN request handling.
**Warning** Be careful when entering a new PIN. There is no way to obtain PIN status after it is
changed. If the PIN is changed after two units have already been authenticated and connected,
you will have to perform a software or hardware reset for the devices to use the new PINs. If this
is not done, the two units will still connect using the old stored PIN.
Format: ATSP,,
Parameters:
New PIN: 16 alphanumeric characters MAX (Caps Sensitive, includes spaces)
Old PIN: 16 alphanumeric characters MAX (Caps Sensitive, includes spaces)
Factory Default: default
EXAMPLE:
TYPE: ATSP,1234567890123456,default
REPLY: OK
OR
ERROR
Note: If security is enabled in multipoint mode, all connected slaves will have to use the same
PIN. There is no way to assign an individual PIN to each slave.
Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360G) 24