Bluetooth Commands - wless.ru
Bluetooth Commands - wless.ru Bluetooth Commands - wless.ru
Chapter 1 – Introduction Repeater Mode Repeater mode can be set using the ATSW25 and ATSMA Commands. Remote Slave Data sent from Repeater UART will broadcast to both units UART outputs NO ANSWER every 10 seconds if remote Slave is not available or CONNECT,00,BTaddress // Master CONNECT,01,BTaddress // Slave BlueRadios ATMP Repeater Generic Master Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360G) 14
Chapter 2 – AT Commands Chapter 2 - AT Commands Introduction Command and Response Formats 1. All commands have the following format: command . Where cr represents carriage return 0x0D. 2. Valid commands respond with OK or ERROR. Where lf represents line feed 0x0A. The only exceptions are ATSW20 and ATURST, which do not reply. 3. Allow at least a 100ms delay between subsequent AT commands. 4. HEX vs. Decimal – When writing or entering integer AT command string values, enter them in decimal format. When reading values from memory, they will be returned in hexadecimal format. 5. If using HyperTerminal, the following check box should be disabled. Send line ends with line feeds. If not, the commands will not be submitted correctly. General Purpose I/O The send I/O pin for DTR can be configured as input or output. It is referred to in this document as follows: 6 = DTR = PIO (6) Attention Command AT – Attention Command Prefix The prefix AT must precede every command except for +++. The remainder of the command line contains commands for the SocketWireless. The command script must end with a carriage return. Example: Type: AT Reply: OK Note: AT Commands can be in upper or lower case. The only exceptions to this are the SocketWireless Personal Identification alphanumeric Number (PIN), which is case sensitive, and ATOP. Firmware Version Command VER Get Firmware Version Format: ATVER, ver1 Return Parameters: Example: Type: ATVER, ver1 Reply: OK Ver 3.6.2.1.0.0 Notes: • "ver1" is case sensitive; use lower case. • Make sure this version number matches this document version before proceeding. Multi-Tech Systems, Inc. SocketWireless Bluetooth AT Commands (S000360G) 15
- Page 1 and 2: Bluetooth ® Commands AT Commands a
- Page 3 and 4: Table of Contents Table of Contents
- Page 5 and 6: Table of Contents RSSI and Link Qua
- Page 7 and 8: Chapter 1 - Introduction Overview C
- Page 9 and 10: Chapter 1 - Introduction Important
- Page 11 and 12: Chapter 1 - Introduction Multipoint
- Page 13: Chapter 1 - Introduction Test Scena
- Page 17 and 18: Chapter 2 - AT Commands Set/Get Dev
- Page 19 and 20: Chapter 2 - AT Commands 11 GET PIO(
- Page 21 and 22: Chapter 2 - AT Commands Security Co
- Page 23 and 24: Chapter 2 - AT Commands SSNC Set Se
- Page 25 and 26: Chapter 2 - AT Commands OP Overwrit
- Page 27 and 28: Chapter 2 - AT Commands SW21 Write
- Page 29 and 30: Chapter 2 - AT Commands SW23 Write
- Page 31 and 32: Chapter 2 - AT Commands SW26 Lock U
- Page 33 and 34: Chapter 2 - AT Commands Read Memory
- Page 35 and 36: Chapter 2 - AT Commands Notes: •
- Page 37 and 38: Chapter 2 - AT Commands Set Master
- Page 39 and 40: Chapter 2 - AT Commands About Comma
- Page 41 and 42: Chapter 2 - AT Commands Pairing Com
- Page 43 and 44: Chapter 2 - AT Commands SSNIFF Enab
- Page 45 and 46: Chapter 2 - AT Commands Notes: •
- Page 47 and 48: Chapter 2 - AT Commands Link Superv
- Page 49 and 50: Chapter 2 - AT Commands Making the
- Page 51 and 52: Chapter 2 - AT Commands • If the
- Page 53 and 54: Chapter 2 - AT Commands FTP Push/Pu
- Page 55 and 56: Chapter 2 - AT Commands OPP Client
- Page 57 and 58: Chapter 2 - AT Commands OPPPUSH Obj
- Page 59 and 60: Chapter 2 - AT Commands OPP Server
- Page 61 and 62: Chapter 4 - Examples Chapter 4 - Ex
- Page 63 and 64: Chapter 4 - Examples DUN Point-to-P
Chapter 1 – Introduction<br />
Repeater Mode<br />
Repeater mode can be set using the ATSW25 and ATSMA <strong>Commands</strong>.<br />
Remote<br />
Slave<br />
Data sent from Repeater UART<br />
will broadcast to both units<br />
UART outputs NO ANSWER every 10<br />
seconds if remote Slave is not available or<br />
CONNECT,00,BTaddress // Master<br />
CONNECT,01,BTaddress // Slave<br />
BlueRadios<br />
ATMP<br />
Repeater<br />
Generic<br />
Master<br />
Multi-Tech Systems, Inc. SocketWireless <strong>Bluetooth</strong> AT <strong>Commands</strong> (S000360G) 14
Change language