CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
NOTE:
While in the Configuration Menu, if no pushbutton is pressed within 60 seconds, the monitor will
automatically save all changes made and exit the Monitor Configuration menu. The Message
Window will briefly display “Saving” and return to the “Ready” mode.
SAVING YOUR CHANGES
When you have completed configuring the monitor, press the CANCEL pushbutton to exit and
lock in your selection(s). The Message Window will briefly display “Saving” and return to the
“Ready” mode.
SOFTWARE REVISIONS
The CASMED 740 Monitor displays the current software revision of its operating system and that
of the internal modules being used inside. The software versions are displayed in the following
order:
Software Module
CASMED 740 Control Board
Boot Loader
Power Supply PIC Processor
CAS NIBP Module
Nellcor SpO 2 Module (1)
Masimo SpO 2 Module (1)
Nonin SpO 2 Module (1)
Welch Allyn Temperature Module (2)
Message Window
Ver X.X
Boot X.XX
PIC X.X
ND X.X
NEL X.X
MAS X.X
NON XX
WA X.X
Table 5: Software Revisions
Use the ARROW UP or ARROW DOWN pushbuttons to view the messages.
Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the
CANCEL pushbutton to Save your changes and exit to the “Ready” mode.
(1) The SpO 2 module is optional, in the case when it is not installed the Version text advances to
the next Module.
(2) The Temperature module is optional, in the case when it is not installed the Version text
advances to the next Module.
21-02-0298 REV. 00 12/06
99