CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
ALARM LIMITS OFF
If the Alarm Limits Off mode is selected in the Monitor Configuration menu, all alarms associated
with patient alarms are “OFF” except for Low Battery and Dead Battery. The visual indicator
next to the SILENCE/RESET pushbutton will flash at a rate of two (2) second “ON” and two (2)
seconds “OFF” and the message “Alrm Off” will be displayed along with the “Ready” message in
the Message Window as a reminder.
When the Alarm Limits Off is selected, the ALARM LIMITS pushbutton is inactive. The Alarm
Limits Off mode cannot be disabled with the SILENCE/RESET pushbutton.
NOTE:
If the Message Window is currently displaying a time stamp from a previously taken NIBP
measurement, the “Alrm Off” message will alternately be displayed with the time stamp
message.
To re-activate the audio alarms, refer to Page 101, AUDIO ALARM SILENCE (SILENCE/RESET
Pushbutton) for more information.
MONITOR CONFIGURATION
The Monitor Configuration section allows the user to configure the CASMED 740 Monitor to your
individual needs. Once entered, the user can:
• Review the monitor’s internal Software Revisions
• Select the Operating Language
• Select the Patient Mode
• Select the Power-Off Delay Time
• Select the Temperature Scale
• Make selections for Audio Alarms
• Choose to display the MAP value
• Set the SpO 2 Alarm Delay
• Set the Date
• Set the Time
• Set Daylight Saving Time Option
• Perform System Checks (Refer to Page 136, CALIBRATION CHECK)
Manometer Mode
Leak Check
ENTERING THE CONFIGURATION MENU
To enter the monitor’s Configuration Menu, press and hold the VOLUME
and ALARM
LIMITS pushbutton keys while the monitor is being turned “ON” .
Once in the menu, use one of the NEXT (HISTORY / VOLUME) or PREVIOUS (CYCLE TIME /
ALARM LIMITS) programmed pushbutton keys to advance onto the next or go back to the
previous parameter in the Configuration Menu.
98
21-02-0298 REV. 00 12/06