CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
CLEARING HISTORY
The History data can be manually cleared by pressing and holding for two (2) seconds the
HISTORY pushbutton while in either of the History modes. The message “Print? N” appears in
the Message Window.
Press the HISTORY pushbutton again and the message “Erase? N” appears in the Message
Window.
Use either the ARROW UP or ARROW DOWN pushbutton until the message “Erase? Y”
appears in the Message Window.
Press the HISTORY pushbutton a final time and the message “Erasing” appears in the Message
Window. The monitor erases the memory, exits the History mode and returns to the “Ready”
state.
REAL TIME CLOCK (RTC)
The CASMED 740 Monitor uses an internal Real Time Clock to time stamp all entries that are
stored in History. Changes made to either the time or date settings, should be performed inbetween
patients being monitored. Refer to Page 85, for displaying the monitors time and Page
104, for setting the time.
PATIENT ALARM MODE
WARNING:
Configuring the CASMED 740 Monitor’s alarm settings to “OFF” will disable all audible and
visual alarms. This mode should only be selected for spot check applications where the patient
is receiving bedside surveillance by a trained clinician. Refer to Page 101, AUDIO ALARM
SILENCE (SILENCE/RESET Pushbutton) for more information.
The CASMED 740 Monitor is equipped with patient alarms to warn the user if any measurement
parameter is outside the range of a user set value. This feature will allow the user to set values
for:
Systolic High and Low
Diastolic High and Low
MAP High and Low
Pulse High and Low
%SpO 2 High and Low
21-02-0298 REV. 00 12/06
91