CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
8) After the temperature measurement is complete, remove the probe from the patient’s
axilla and eject the probe cover by firmly pressing the ejection button on the probe.
Properly dispose of the used probe cover per protocol.
9) Insert the probe into the probe holder before attempting to take another temperature
measurement. An audible “click” should be heard when the SureTemp® probe is
completely placed into its holder. The SureTemp Plus® probes will slide in and out of
the Probe Well without any restrictions.
NOTE:
Failure to correctly place the probe back into its holder may result in failure of the next predictive
temperature measurement.
10) Following a completed temperature measurement, the current temperature
measurement is displayed for five (5) minutes after which time the TEMP display will
go blank.
INSERTING & REMOVING PROBE WELL (SureTemp Plus® Only)
CAUTION:
When replacing a SureTemp Plus probe, it is recommended to replace the Probe Well received
with the probe. Failure to replace the Probe Well could result in patient cross contamination.
1) To insert – Position the Probe Well with the flat sides toward the front and rear of the
monitor. Slide the Probe Well into the opening at the top of the Temperature module.
Push the Probe well all the way down the opening. An audible “click” should be
heard when the Probe Well is completely placed into its holder. Refer to Figure 12.
2) To remove – Grasp the Probe Well by the flared ring. Gentle pull the Probe Well
straight up and continue until the Probe Well is completely out of the opening. Refer
to Figure 12.
21-02-0298 REV. 00 12/06
67