CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
NONIN® OXIMETER (if so equipped)
The CASMED 740 Monitor can be equipped to use SpO 2 sensors manufactured by Nonin. No
other manufacturer’s sensors should be used.
NOTE:
CASMED 740 Monitors equipped with Nonin oximetry will have the Nonin logo next to the SpO 2
connector.
ATTACHING THE SENSOR CABLE
1) Select and apply a sensor that is the appropriate size for the patient’s digit or extremity,
according to the instructions provided by Nonin.
2) Plug the sensor assembly into the SpO 2 connector on the side panel of the monitor. The
connector is shaped like a “D”. Line up the “D” on the sensor cable with the “D” on the
receptacle. Push the connector in completely.
3) Press the ON/STANDBY pushbutton to turn “ON” the monitor.
4) Check the Alarm Limits and configure them appropriately for the patient. Refer to Page
91, PATIENT ALARM MODE for more information.
REMOVING THE SENSOR CABLE
When SpO 2 monitoring is not required, disconnect the Sensor Cable by carefully removing the
connector from the SpO 2 input receptacle.
NOTE:
To avoid damage to the Sensor Cable, always hold it by the connector rather than the cable
when connecting or disconnecting either end.
When the probe is disconnected from the monitor, the message “No Probe” appears in the
Message Window and an audible alarm sounds indicating a connection has been broken. Press
the SILENCE/RESET pushbutton to silence the visual and audible alarm.
NOTE:
If either the 2-Minute Audio Off or Permanent Audio Off is enabled, no audio will be heard but a
visual message will appear in the Message Window.
Refer to Section 13, ACCESSORIES for Nonin oximeter probe types and part number
information. Consult instructions enclosed with each sensor for proper application.
58
21-02-0298 REV. 00 12/06