CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
5) Press the ON/STANDBY pushbutton to turn “ON” the monitor.
6) Check the Alarm Limits and configure them appropriately for the patient. Refer to Page
91, PATIENT ALARM MODE for more information.
REMOVING THE INTERFACE CABLE
When SpO 2 monitoring is not required, disconnect the Interface Cable by squeezing the grey
tabs with your thumb and index finger while pulling the connector away from the monitor.
NOTE:
To avoid damage to the Interface Cable, always hold it by the connector rather than the cable
when connecting or disconnecting either end.
When the probe is disconnected from the monitor, the message “No Probe” appears in the
Message Window and an audible alarm sounds indicating a connection has been broken. Press
the SILENCE/RESET pushbutton to silence the visual and audible alarm.
NOTE:
If either the 2-Minute Audio Off or Permanent Audio Off is enabled, no audio will be heard but a
visual message will appear in the Message Window.
Refer to Section 13, ACCESSORIES for Masimo oximeter probe types and part number
information. Consult instructions enclosed with each sensor for proper application.
MASIMO MESSAGES
When the message “Low Perf” or “Low Sig” appear in the Message Window, and the monitor is
displaying valid %SpO 2 numerics, no audible alarm will be heard.
When the message “Low Perf” or “Low Sig” appear in the Message Window, and the monitor is
not displaying valid %SpO 2 numerics, an audible alarm will be heard. Press the
SILENCE/RESET pushbutton. The monitor silences the audio alarm tone, but the message
remains.
56
21-02-0298 REV. 00 12/06