CASMED 740 Vital Signs Monitor - Implox
CASMED 740 Vital Signs Monitor - Implox
CASMED 740 Vital Signs Monitor - Implox
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CASMED</strong> <strong>740</strong> <strong>Monitor</strong>s<br />
CHARGING THE PRINTER BATTERY<br />
The CMP-10 Mobile Printer is equipped with a rechargeable Lithium Ion (LiION) battery pack.<br />
When the printer detects a Low Battery condition within itself, the message “Low Battery” is<br />
printed and an audio indicator, located inside the printer sounds three (3) times.<br />
WARNING:<br />
Charge the printer battery using the AC Adapter, Model TRC-09-1100-M from GROUP WEST,<br />
or equivalent, included with the printer.<br />
Plug the battery charger’s cord into the printer battery charger jack, located on the rear panel.<br />
Plug the charger into an AC wall outlet of the appropriate voltage. Verify the CHARGE LED<br />
indicator is lit Red. Battery charge time is approximately three (3) hours. Once the battery is<br />
fully charged, the CHARGE LED indicator switches to Green.<br />
INSTALLING PAPER<br />
NOTE:<br />
A red line appears when the remaining supply of thermal paper becomes low.<br />
1) Switch the printer “OFF”.<br />
2) Press the Cover Open button to access the paper compartment. Remove any remaining<br />
paper before installing the new roll.<br />
3) Place the new paper roll as shown on the illustration and pull out enough paper to reach<br />
out over the control panel of the printer.<br />
4) Close the paper door.<br />
Figure 22: Paper Installation<br />
21-02-0298 REV. 00 12/06<br />
123