CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
PRINTER OPERATION
DIRECT CONNECTION
The monitor uses the DB9 connector, located on the rear panel of the monitor to interface to the
RS232 port on the printer. Use the cable which is supplied with the printer.
NOTE:
When using the direct connect method, connect the printer’s serial cable to the printer before
turning the printer on.
INFRARED CONNECTION
NOTE:
When using the infrared port, disconnect the printer’s serial cable from the printer before turning
the printer on.
Position the printer’s IrDA port window in-line with the IrDA window of the CASMED 740 Monitor
OR connect the RS232 direct cable from the printer to the 9-pin RS 232 connector, located on
the rear panel of the CASMED 740 Monitor.
NOTE:
When using the IrDA port for printing, it is recommended to keep all items clear of the
communications path between the monitor and the printer.
Turn the printer “ON”. To turn the printer “ON”, press and hold the ON/OFF pushbutton for one
(1) second. The Power LED illuminates Green.
To turn the printer “OFF”, press and hold the ON/OFF pushbutton. The Power LED will
illuminate Red and change back to Green. When the LED illuminates Green, remove your finger
from the pushbutton.
NOTE:
If the printer was powered “ON” during the monitor’s power-up sequence, the CAS Medical
Systems logo is printed.
The CMP-10 Mobile Printer contains an Auto Power Off feature. If the monitor and printer
become separated and after ten (10) minutes during which no data has been sent to the printer
and the Line Feed (LF) pushbutton has not been pressed, the printer will automatically shutoff.
The CASMED 740 Monitor will periodically send to the printer a “wake-up” message that will
disable the Auto Power Off feature.
21-02-0298 REV. 00 12/06
121