CASMED 740 Vital Signs Monitor - Implox
CASMED 740 Vital Signs Monitor - Implox
CASMED 740 Vital Signs Monitor - Implox
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CASMED</strong> <strong>740</strong> <strong>Monitor</strong>s<br />
CAUTION:<br />
This product contains a rechargeable battery that is recyclable. Under various state and local<br />
laws, it may be illegal to dispose of this battery into the municipal waste stream. Check with your<br />
local authorities for instructions on recycling options in your area.<br />
AUTO OFF FEATURE<br />
The <strong>CASMED</strong> <strong>740</strong> <strong>Monitor</strong> incorporates an Auto “OFF” feature to preserve battery life. The Auto<br />
Off feature is enabled automatically when the user selects the “Alrm Off” option in the<br />
Configuration Menu.<br />
When the monitor is in this mode and if accidentally left powered “ON” for ten (10) minutes<br />
without any key presses or any parameters active, the monitor will beep for five (5) seconds prior<br />
to automatically shutting itself down to preserve battery life.<br />
For the Auto “OFF” feature to work properly, the following conditions must apply;<br />
• “Alrm Off” is selected in the Configuration Menu.<br />
• The <strong>CASMED</strong> <strong>740</strong> <strong>Monitor</strong> is operating on battery power.<br />
• No NIBP, SpO 2 or Temperature readings were taken in the past ten (10) minutes.<br />
• No key presses were made in the past ten (10) minutes.<br />
• The monitor cannot be in the Automatic NIBP cycle mode.<br />
POWER FAIL<br />
The <strong>CASMED</strong> <strong>740</strong> <strong>Monitor</strong> incorporates a Power Fail feature. Whenever the power is<br />
disconnected from the monitor and the monitor is not allowed to shut down in an orderly fashion,<br />
the monitor, when re-powered alerts the user. The message “Pwr Fail” is displayed in the<br />
Message Window and three (3) audio “beeps” followed by two (2) audio “beeps” are heard every<br />
ten (10) seconds.<br />
During this condition, all other pushbuttons are inactive except for the ON/STANDBY and<br />
SILENCE/RESET.<br />
To clear the Power Fail condition, and return to “Ready”, press the SILENCE/RESET pushbutton<br />
or recycle the monitor’s power.<br />
USER MESSAGES<br />
The <strong>CASMED</strong> <strong>740</strong> <strong>Monitor</strong> displays a variety of messages to aid the user in monitor operation.<br />
If a troubleshooting message is displayed during a measurement, follow the actions listed to<br />
correct the situation.<br />
If the monitor does not turn on, or exhibits a flashing display and failure to operate, the battery is<br />
most likely below the Dead Battery point. Connect the monitor to a power source (AC Line<br />
Power or +12 VDC) and allow it to charge for four (4) hours.<br />
108<br />
21-02-0298 REV. 00 12/06
Change language